27 February 2023 in Physica B: Condensed Matter
1 November 2021 in Journal of Alloys and Compounds
MMMartin I. Miranda-López
ABAlexander N. Bondarchuk
+1
19 October 2024 in Materials Chemistry and Physics
MHMiguel Hesiquio-Garduño
+2
5 September 2026 in Surfaces and Interfaces
25 July 2026 in SSRN Electronic Journal
SnO2-based varistor thin films were prepared by ultrasonic spray pyrolysis (USP) on aluminum-doped zinc oxide (AZO)-coated glass substrates using a multideposition strategy. The deposited composition was derived from an optimized ceramic varistor system containing SnO2, Co3O4, Cr2O3, Nb2O5, and SrTiO3. The number of deposition cycles varied from 10 to 40, and the influence of post-deposition thermal treatment was evaluated to determine its role in film consolidation and electrical activation. Scanning electron microscopy coupled with energy-dispersive X-ray spectroscopy (SEM-EDS) analysis showed that a single deposition produced discontinuous coverage, whereas multideposition progressively improved surface homogeneity and reduced exposed substrate regions. X-ray diffraction (XRD) and Raman spectroscopy confirmed that the cassiterite SnO2 phase remained the dominant crystalline structure before and after thermal treatment, with no secondary phases detected within the resolution of the techniques. X-ray photoelectron spectroscopy (XPS) analysis confirmed the chemical stability of the SnO2 matrix and the predominance of the Sn4+ oxidation state after treatment. Profilometry revealed a systematic increase in film thickness with the number of depositions, while the thermally treated films showed higher apparent thickness values associated with coating reorganization and surface-profile evolution. The untreated films did not exhibit measurable non-ohmic behavior; in contrast, thermally treated films showed activated nonlinear electrical response. The highest nonlinear coefficient was obtained for the 30T film (α = 3.50), whereas the 40T film exhibited the highest breakdown field (Eb = 129.3 V/cm). These results demonstrate that USP, combined with multideposition and thermal treatment, is a viable route to translate SnO2-based ceramic varistors into functional thin-film architectures for low-voltage surge-protection applications.