4 December 2019 in Nature
15 September 2022 in Nature Materials
6 June 2023 in Nature Communications
In recent research, additions of solute to Ti and some Ti-based alloys have been employed to produce equiaxed microstructures when processing these materials using additive manufacturing. The present study develops a computational scheme for guiding the selection of such alloying additions, and the minimum amounts required, to effect the columnar to equiaxed microstructural transition. We put forward two physical mechanisms that may produce this transition; the first and more commonly discussed is based on growth restriction factors, and the second on the increased freezing range effected by the alloying addition coupled with the imposed rapid cooling rates associated with AM techniques. We show in the research described here, involving a number of model binary as well as complex multi-component Ti alloys, and the use of two different AM approaches, that the latter mechanism is more reliable regarding prediction of the grain morphology resulting from given solute additions.
25 October 2021 in Metallurgical and Materials Transactions A
This paper addresses the use of alloying additions to titanium alloys for additive manufacturing (AM) with the specific objective of producing equiaxed microstructures. The additions are among those that increase freezing ranges such that significant solutal undercooling results when combined with the rapid cooling rates associated with AM, and so be effective in inducing a columnar-to-equiaxed transition (CET). Firstly, computational thermodynamics has been used to provide a simple graphical means of predicting these additions; this method has been used to explore additions of Ni and Fe to the alloy Ti–6Al–4V (Ti64). Secondly, an experimental means of determining the minimum concentration of these alloying elements required to effect the CET has been developed involving gradient builds. Thirdly, it has been found that additions of Fe to Ti64 cause the alloy to change from an α/β Ti alloy to being a metastable β-Ti alloy, whereas additions of Ni do not produce the same result. This change in type of Ti alloy results in a marked difference in the development of microstructures of these compositionally modified alloys using heat treatments. Finally, hardness measurements have been used to provide a preliminary assessment of the mechanical response of these modified alloys.
30 September 2022 in Scripta Materialia
1 November 1988 in Philosophical Magazine A
A new transmission electron microscopy technique is described, convergent-beam imaging (CBIM), in which an image is formed using a convergent beam focused above or below a thin crystalline specimen. Superimposed on the image are higher-order Laue zone (HOLZ) lines, the displacements of which map the spatial variation of strains, lattice parameters and crystallographic rotations. The image has its normal resolution, the superimposed diffraction information has an angular resolution of about 10−4 rad, and this diffraction information comes from regions of the specimen defined approximately by the cross-over size of the electron probe size, broadened by beam spreading. The visibility of HOLZ lines in the CBIM image is significantly improved by cooling the specimen. The CBIM technique is illustrated by its application to a Si/GexSi1−x strained-layer structure, where spatial changes in the lattice parameter and crystal symmetry are revealed by the relative positions of the HOLZ lines in the Si and alloy layers. Moreover, distortions arising from surface relaxation effects near the Si/GexSi1−x interfaces can be directly visualized from the curvature of HOLZ lines as these lines cross an interface. The CBIM technique has general application to the investigation of crystalline systems where localized variations in strain, lattice parameter, crystal symmetry and crystallographic rotation are of interest.