This paper reports on a symmetrical z-axis gyroscope, whose stiffness of sensing and driving mode is identical in spite of the fabrication and design errors. There is no need of the electrical tuning of frequencies for a high sensitivity because the effective masses of the driving and sensing directions are hardly changed. Furthermore, it is very simple to fabricate the gyroscope with a total chip size of 3/spl times/3.5/spl times/1 mm/sup 2/ using only one mask. The gyroscope structure is fabricated on an anodic bonded 40 /spl mu/m-thick silicon on glass. After the top silicon is etched using a deep RIE, a part of the glass under the silicon structure is etched by HF for releasing the top silicon structure. Since the depth of the etched glass under the silicon structure is about 20/spl sim/30 /spl mu/m, the damping and the stiction between the structure and the glass substrate are minimized. The minimum gap and the aspect ratio of this structure is 2 /spl mu/m and 20, respectively. Without an additional frequency tuning method, it is demonstrated that the difference between the two frequencies is about 85 Hz, and the noise equivalent rate is 0.01 deg/sec at 50 mTorr pressure.
22 August 2012 in Japanese Journal of Applied Physics
In this study, a transparent conductive-polymer-based sensor array designed for use in a touch screen panel was fabricated using soft lithography. One of the most promising conductive polymers, poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS), was used as the conductive material, and the secondary dopant dimethyl sulfoxide (DMSO) was used to increase the conductivity. The experiments were conducted using various DMSO concentrations in PEDOT:PSS in order to identify the optimum conditions to achieve high conductivity and transmittance. The electrical properties of PEDOT:PSS thin films were investigated using a four-point probe, and their transmittance was determined using an UV–vis spectrometer. The surface morphology was observed by field emission scanning electron microscopy (FE-SEM) and atomic force microscopy (AFM). A stable conductivity in the range of 110–204 S/cm was obtained at 0–30% DMSO concentrations, and the transmittances were greater than 92% in the visible range.
We introduce a horizontal array capacitor with nine capacitances in a single body using an organic dielectric layer impregnated with glass fiber as a prepreg sheet. An organic solid horizontal array capacitor with a dielectric of prepreg materials of the epoxy type can implement the nine capacitances in a single body via a unique simple lamination and cutting process. We then investigate the basic electrical properties of a horizontal array capacitor. The organic solid array capacitors with five electrodes and four dielectrics are Cu/PPG layer/Cu/PPG layer/Cu/PPG layer/Cu/PPG layer/Cu with a horizontal array structure. The size of a completed array capacitor is 2.85 × 2.85 mm. The height of the fabricated array capacitor in the vertical direction is 0.5 mm, with nine capacitances possessing a series-type structure. The average capacitance value of C1, C2, C3, and C4 is 1.98 nF, and each tolerance has a value within 1% based on the average value. The temperature change rate in the capacitance maintains a nearly linear characteristic, but the rate of change tends to increase finely from 120°C or more. The capacitance values of C5, C6, and C7 with the parallel circuit were measured according to the voltage. Impedance and ESR (equivalent series resistor) of C1 were measured according to frequency and temperature.