Shohei Seki

Shohei Seki

Auto-generated profile, based on publicly available information

Shohei Seki

Niigata University

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2023 in Physics of Fluids
Verified
Journal Article
Open access
PDF file
DMDaichi Moteki
Daichi Moteki
SSShohei Seki
Shohei Seki
SMShogo Muramatsu
Shogo Muramatsu
KHKiyoshi Hayasaka
Kiyoshi Hayasaka
HYHiroyasu Yasuda
Hiroyasu Yasuda
In channelized alluvial rivers, alternating sandbars are formed by alternating scouring and sedimentation in the downstream direction. The conditions for the occurrence of sandbars are obtained in the stability analysis as when the ratio of channel width to depth, $\beta$, exceeds a critical value due to innate instability of bottom. However, neither the mechanism nor the conditions for the occurrence of sandbars are well understood because it is difficult to quantify bars before or early in the occurrence of that using conventional measurement methods. We conducted experiments in a laboratory flume with slope as a variable to obtain dense data on the geometry of the water surface, bottom surface, and flow depth. We then performed a wavenumber analysis of the measured data to verify the validity of the results estimated by the stability analysis. We calculated the temporal variation of the correlation coefficients between the depth--water surface $r_{wl}$ and depth--bottom $r_{bl}$ along the development stage of the sandbar since flow state could be estimated from the relationship between the flow depth and the water surface/bottom surface. The temporal variation of the correlation suggests that the development process of sandbars can be divided into three phases, and the flow state is different for each phase. We also found that the occurrence time of sandbars would be defined based on the intersection of the temporal variation of $r_{wl}$ and $r_{bl}$. Furthermore, we show that the formation process of the sandbar is independent of Fr.

1 October 2023 in Physics of Fluids
Verified
Journal Article
Open access
PDF file
SSS. Seki
S. Seki
DMD. Moteki
D. Moteki
HYH. Yasuda
H. Yasuda
The mechanism of sandbar initiation and formation is unresolved. The occurrence of sandbars has been investigated using stability analysis, which assumes that sandbars occur due to the inherent instability of a riverbed. However, there are no data, either from riverine observations or model experiments, to support this assumption. Here, we conducted flume experiments in which sandbars were formed from a flatbed by simultaneously measuring the water surface and bottom surface. The results showed that the process of sandbar initiation and formation first involves the generation of small periodic bedforms; then, the bedforms transition to small three-dimensionally shaped rhomboid bars, and finally, the rhomboid bars transition to sandbars. The measurements also suggested that wave trains occurred on the water surface. We then conducted fixed-bed experiments under the same conditions as a moving bed to ascertain the behavior of the water surface. The results of these fixed-bed experiments showed that standing waves were observed on the water surface even when the experimental conditions were steady and the flatbed channel was straight. A two-dimensional wavenumber analysis showed that the dominant wavenumbers of the standing waves and initial small bedforms were in good agreement. The whole set of results indicated that standing waves were already present on the water surface before bedforms occurred and that one of the factors in sandbar initiation was the presence of the standing waves on the water surface.

11 February 2026
Verified
Preprint
Open access
SSShohei Seki
Shohei Seki
DMDaichi Moteki
Daichi Moteki
HYHiroyasu Yasuda
Hiroyasu Yasuda
Alternate bars are ubiquitous bedforms in alluvial rivers, and excessive bar-height growth can disrupt river ecosystems and increase flood risk. Predicting bar-height variability requires quantifying the dependence of bar growth rate on water discharge, yet this has rarely been achieved because conventional flume measurements interrupt the flow, preventing continuous capture of bar evolution. Here we conducted laboratory experiments under four discharges and four channel slopes (16 conditions) and continuously mapped bed topography using Stream Tomography, a nonintrusive, flow-through measurement technique. Bar height exhibits sigmoidal growth and is well described by the general solution of the Landau equation, allowing robust estimation of the linear growth rate and equilibrium amplitude for each condition. The inferred dimensionless growth rate decreases monotonically with increasing discharge, but its sensitivity to discharge is up to three times weaker than predicted by linear stability theory. This discrepancy becomes more pronounced at lower discharge, indicating limitations of linearization and the influence of interactions among multiple bar modes. Numerical flow simulations over the measured bed topography further reveal that, at low discharge, a large bar height-to-depth ratio enhances flow deflection around bar crests, concentrates sediment transport in scour zones, and slows bar migration. These processes stabilize scour locations and promote bar-height growth. Together, these results provide benchmark constraints for bar stability theories and improve predictions of bar-height variability under changing discharge regimes.

11 September 2023
Verified
Preprint
Open access
PDF file
SSShohei Seki
Shohei Seki
SSS Seki
S Seki
DMD Moteki
D Moteki
HYH Yasuda
H Yasuda
The mechanism of sandbars initiation and formation is unresolved. The occurrence of sandbars has been investigated using stability analysis, which assumes that sandbars occur due to the inherent instability of a riverbed. However, there are no data, either from riverine observations or model experiments, to support this assumption. Here, we conducted flume experiments in which sandbars were formed from a flatbed by simultaneously measuring the water surface and bottom surface. The results showed that the process of sandbars initiation and formation first involves the generation of small periodic bedforms; then, the bedforms transition to small three-dimensionally shaped rhomboid bars, and finally the rhomboid bars transition to sandbars. The measurements also suggested that wave trains occurred on the water surface. We then conducted fixed-bed experiments under the same conditions as a moving bed to ascertain the behavior of the water surface. The results of these fixed-bed experiments showed that standing waves were observed on the water surface even when the experimental conditions were steady and the flatbed channel was straight. A two-dimensional wavenumber analysis showed that the dominant wavenumbers of the standing waves and initial small bedforms were in good agreement. The whole set of results indicated that standing waves were already present on the water surface before bedforms occurred and that one of the factors in sandbars initiation was the presence of standing waves on the water surface.