13 November 2017 in Energy & Environmental Science
High faradaic efficiency reduction of N2 to NH3 is achieved in ionic liquid media under ambient conditions.
20 April 2016 in Nature Communications
Ammonia (NH3) is one of the most widely produced chemicals worldwide. It has application in the production of many important chemicals, particularly fertilizers. It is also, potentially, an important energy storage intermediate and clean energy carrier. Ammonia production, however, mostly uses fossil fuels and currently accounts for more than 1.6% of global CO2 emissions (0.57 Gt in 2015). Here we describe a solar-driven nanostructured photoelectrochemical cell based on plasmon-enhanced black silicon for the conversion of atmospheric N2 to ammonia producing yields of 13.3 mg m−2 h−1 under 2 suns illumination. The yield increases with pressure; the highest observed in this work was 60 mg m−2 h−1 at 7 atm. In the presence of sulfite as a reactant, the process also offers a direct solar energy route to ammonium sulfate, a fertilizer of economic importance. Although the yields are currently not sufficient for practical application, there is much scope for improvement in the active materials in this cell.
1 June 2015 in Angewandte Chemie International Edition
16 September 2014 in Journal of Materials Chemistry A
In this paper, we report a UV/ozone-assisted method for low temperature preparation of mesoporous TiO2 with controlled crystalline phase. The results showed that the crystallization of mesoporous TiO2 can occur at temperatures as low as 100 °C under UV/ozone irradiation. Highly crystalline mesoporous anatase TiO2 was obtained after UV/ozone treatment at 200 °C. The phase transformation from anatase to rutile occurred during the UV/ozone treatment at 300 °C and mesoporous bicrystalline TiO2 with a controlled mixture of anatase and rutile phases was prepared by adjusting the exposure time. The photocatalytic performance of the mesoporous TiO2 strongly depends on the crystal structures and the bicrystalline mesoporous TiO2 exhibits remarkably enhanced solar light photocatalytic activity. This technique can be useful for low temperature preparation of crystalline mesoporous titania on various substrates and may be generalized to the synthesis of other materials.
13 August 2026 in ChemistrySelect
Contamination of freshwater resources with heavy metals constitutes a pivotal threat to the environment and human health. Formulating cost‐effective and recyclable materials for efficient metal removal consequently evolved into a major research priority. In this work, we report the design of sustainable and inexpensive polyacrylic hydrogels with improved swelling and adsorption characteristics, enabling the efficient removal of heavy metal ions from water sources. Two hydrogels were synthesized and later comprehensively characterized using Fourier‐transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), Brunauer–Emmett–Teller (BET) surface analysis, and thermogravimetric analysis (TGA). Contact time, pH, and temperature on the adsorption efficiency were evaluated systematically for Ni 2 + and Co 2 + ions. 4‐Br hydrogel showed a better ion extraction ability, accomplishing 96% for Ni 2 + and 88% for Co 2 + under optimized conditions (pH 6.5, 30°C, 24 h). Also, after multiple cycles of regeneration, the hydrogel retained its adsorption abilities, validating the hydrogel's capabilities for sustainable water treatment. These results emphasize the viability of polyacrylic hydrogels as a relatively low‐cost, recyclable, and highly efficient adsorbent for the detoxification of wastewater from heavy metals and many other environmental management applications.