19 October 2011 in Physical Review Letters
Using angular resolved photoemission spectroscopy we studied the evolution of the surface electronic structure of the topological insulator Bi2Se3 as a function of water vapor exposure. We find that a surface reaction with water induces a band bending, which shifts the Dirac point deep into the occupied states and creates quantum well states with a strong Rashba-type splitting. The surface is thus not chemically inert, but the topological state remains protected. The band bending is traced back to Se abstraction, leaving positively charged vacancies at the surface. Because of the presence of water vapor, a similar effect takes place when Bi2Se3 crystals are left in vacuum or cleaved in air, which likely explains the aging effect observed in the Bi2Se3 band structure.
13 May 2010 in Journal of the American Chemical Society
1 October 2006 in Chemical Physics Letters
1 November 2002 in Applied Surface Science
11 November 2008 in Physical Review B
Using a combination of reciprocal and real-space techniques, the structural evolution and its effect on the surface morphology is investigated for MgO films of 1–30 ML thickness epitaxially grown on Mo(001). The strain induced by the mismatch with the substrate is relieved between 1 and 7 ML MgO due to the formation of an ordered network of interfacial misfit dislocations aligned along the MgO directions, particularly evident after annealing the film at 1070 K. A dislocation periodicity of about has been determined by means of grazing incidence x-ray diffraction. The dislocations induce a tilting of the surface that appears in electron diffraction along the MgO directions for thin films and changes to directions when the oxide thickness increases. Scanning tunneling microscopy (STM) shows the presence of a regular pattern on the surface below 7 ML thickness associated to the dislocation network. With increasing thickness, screw dislocations connected by nonpolar steps appear on the oxide surface. Thanks to the combination of different diffraction techniques and STM measurements, a comprehensive picture of the relaxation mechanisms in MgO films on Mo(001) can be drawn.
13 April 2015 in Physical Review B
Theoretical and experimental studies agree that is a three-dimensional topological insulator. However, there is still a debate on the corresponding surface band structure. While three spin polarized bands have been claimed experimentally, theoretically, only two surface bands appear, with the third band being attributed to surface imperfections. Here, we address this controversy using angle-resolved photoemission spectroscopy (ARPES) on films. To minimize surface imperfections, we have optimized the sample growth recipe. We have measured the evolution of the surface band structure of with increasing gradually from to . Our ARPES data show better agreement with the theoretical calculations, where the system is topologically nontrivial with two surface bands.