29 August 2014 in Chemical Communications
In this work, we developed a general two-step method to prepare molybdenum carbide (Mo2C) nanoparticles stabilized by a carbon layer on reduced graphene oxide (RGO) sheets. The Mo2C–RGO hybrid showed excellent performance, which is attributed to the intimate interactions between Mo2C and graphene as well as the outer protection of the carbon layer.
2 August 2019 in Science Advances
Co 3 Sn 2 S 2 hosts Co atom–derived surface states at the Kagome lattice, favoring the electron transfer process in oxygen evolution.
3 August 2015 in Chemical Communications
Hierarchical CoMoO 4 micro-flowers assembled from ultrathin nanosheets exhibit substantially higher electrocatalytic activity and stability than the IrO 2 benchmark towards oxygen evolution.
28 May 2015 in Journal of Materials Chemistry A
A Mn3O4/Ni foam electrode prepared by a facile method exhibits excellent electrocatalytic performance for the oxygen evolution reaction.
30 January 2019 in ACS Applied Energy Materials
A specific investigation was carried out to study the influence of Ni/Fe ratio for oxygen evolution reaction (OER) by using hard templating method as a toolbox. Various compositions of homogeneously blended Ni-Fe oxide nanoparticles with a primary particle size of around 8 nm were simply prepared by using pore confinement of the tea leaves template. Based on the similar physical properties including particle size and surface area for all samples, it was verified that the OER activity in alkali electrolyte was mainly governed by the metal stoichiometry, where a maximum current density was obtained with Ni/Fe ratio of 32/1. The higher catalytic performance of Ni32Fe was attributed to lower reaction resistance and higher intrinsic activity, which are confirmed by electrochemical impedance spectroscopy and surface area analysis, respectively. The lowest overpotential (0.291 VRHE at 10 mA/cm2) as well as the highest current density (over 600 mA/cm2 at 1.7 VRHE) was achieved with Ni/Fe 32/1 loaded on nickel foam due to (i) an uniform distribution of Fe into NiO, (ii) a high conductivity, and (iii) an activation of Ni by neighboring Fe under applying bias. The environmentally-benign surfactant-free synthetic procedure and the electrocatalytic system consisting of earth-abundant elements only (Fe, Ni, and O) should be attractive for the development of practical and economical energy conversion devices to split water.
1 August 2019 in ACS Catalysis
We report a simple and effective electrochemical method to remove Fe impurities from commercial KOH electrolyte. We therefore utilize a MoS2 catalyst deposited on porous Ni foam as both the anode and cathode in a two-electrode electrolysis setup. After 12 h of constant galvanostatic electrolysis at 100 mA, the Fe impurities from the KOH electrolyte were successfully removed, as confirmed by means of inductively coupled plasma optical emission spectroscopy analysis. In the purified KOH, a Ni–Co3O4 composite oxide catalyst showed no Fe-induced activation. In contrast, we directly observed the uptake of Fe on the Ni–Co3O4 catalyst from the nontreated electrolyte during catalyst operation using a coupled spectroelectrochemical setup. Interestingly, we further identified an influence on the dissolution behavior of Ni and Co in the presence of Fe impurities. Whereas hitherto mainly the activation effect of Fe impurities has been discussed, we hereby show that they additionally suppress corrosion under reaction conditions. Using our fast and low-cost method for the purification of large amounts of electrolyte, catalyst materials can be widely studied without these additional effects induced by Fe impurities in commercial KOH.