High-quality Ga2O3 thin films in the orthorhombic κ-phase are grown by pulsed-laser deposition using a tin containing target on c-sapphire, MgO(111), SrTiO3(111), and yttria-stabilized ZrO2(111) substrates. The structural quality of the layers is studied based on the growth parameters employing X-ray diffraction 2θ-ω scans, rocking curves, ϕ scans, and reciprocal space maps. Our layers exhibit superior crystalline properties in comparison to thin films deposited in the monoclinic β-phase at nominally identical growth parameters. Furthermore, the surface morphology is significantly improved and the root-mean-squared roughness of the layers was as low as ≈0.5 nm, on par with homoepitaxial β-Ga2O3 thin films in the literature. The orthorhombic structure of the thin films was evidenced, and the epitaxial relationships were determined for each kind of the substrate. A tin-enriched surface layer on our thin films measured by depth-resolved photoelectron spectroscopy suggests surfactant-mediated epitaxy as a possible growth mechanism. Thin films in the κ-phase are a promising alternative for β-Ga2O3 layers in electronic and optoelectronic device applications.
High-quality (InxGa1−x)2O3 thin films in the orthorhombic κ-phase were grown by pulsed-laser deposition (PLD) on c-sapphire substrates as well as PLD-grown κ-Ga2O3 thin film templates. We varied the In-content 0 ≤ x ≤ 0.38 of the layers using a single, elliptically segmented, and tin-doped (In0.4Ga0.6)2O3/Ga2O3 target, employing the vertical continuous composition spread (VCCS) PLD-technique. A stoichiometric transfer of In and Ga from the target to the thin films has been confirmed, suggesting that the formation of volatile Ga2O and In2O suboxides is not a limiting factor in the tin-assisted growth mode. For all x, the thin films crystallized predominantly in the κ-modification as demonstrated by XRD 2θ-ω scans. However, for x > 0.28, phase separation of the cubic bixbyite and the κ-phase occurred. The κ-Ga2O3 template increased the crystalline quality of the κ-(InxGa1−x)2O3 thin film layers remarkably. Epitaxial, but relaxed growth with three in-plane rotational domains has been found for all thin films by XRD ϕ-scans or reciprocal space map measurements. Smooth surface morphologies (Rq < 3 nm) for all phase pure thin films were evidenced by atomic force microscopy measurements, making them suitable for multilayer heterostructures. The composition-dependent in- and out-of plane lattice constants follow a linear behavior according to Vegard’s law. A linear relationship can also be confirmed for the optical bandgaps that demonstrate the feasibility of bandgap engineering in the energy range of 4.1–4.9 eV. The results suggest κ-(InxGa1−x)2O3 as a promising material for heterostructure device applications or photodetectors.
The structural, surface, and optical properties of phase-pure κ-(AlxGa1−x)2O3 thin films on c-sapphire and STO(111):Nb substrates as well as on MgO(111) and κ-Ga2O3 templates are reported as a function of alloy composition for x < 0.4. The thin films were grown by tin-assisted pulsed laser deposition (PLD). For the variation of the Al-content, we utilized radially segmented PLD targets that enable the deposition of a thin film material library by discrete composition screening. Growth on κ-Ga2O3 (001) thin film templates enhanced the phase pure growth window remarkably up to x = 0.65. The crystallization of the κ-phase was verified by X-ray diffraction 2θ-ω-scans for all samples. Both in- and out-of-plane lattice constants in dependence on the Al-content follow a linear relationship according to Vegard’s law over the complete composition range. Atomic force microscope measurements confirm smooth surfaces (Rq ≈ 1.4 nm) for all investigated Al-contents. Furthermore, bandgap tuning from 4.9 eV to 5.8 eV is demonstrated and a linear increase in the bandgap with increasing Al-content was observed.
Material properties of orthorhombic κ-phase (InxGa1−x)2O3 thin films grown on a c-plane sapphire substrate by pulsed-laser deposition are reported for an indium content up to x ∼ 0.35. This extended range of miscibility enables band gap engineering between 4.3 and 4.9 eV. The c-lattice constant as well as the bandgap depends linearly on the In content. For x > 0.35, a phase change to the hexagonal InGaO3(ii) and the cubic bixbyite structure occurred. The dielectric function and the refractive index were determined by spectroscopic ellipsometry as a function of the alloy composition. We propose zirconium to induce n-type conductivity and have achieved electrically conducting thin films with a room temperature conductivity of up to 0.1 S/cm for samples with a low In content of about x = 0.01. Temperature-dependent Hall-effect measurements yielded a thermal activation energy of the free electron density of 190 meV. Schottky barrier diodes with rectification ratios up to 106 were investigated by quasi-static capacitance voltage and temperature-dependent current voltage measurements.
Novel devices based on orthorhombic could enable solar blind infrared detection or high-electron mobility transistors with large two-dimensional electron gas densities. Here, we report on the current transport parallel to the growth direction of layers grown by pulsed-laser deposition on highly conductive Al-doped ZnO back contact layers. Besides ohmic Ti/Al/Au contact layer stacks, vertical and Schottky barrier diodes and and -heterodiodes are investigated by current–voltage measurements. While a lateral current transport is severely suppressed to less than due to rotational domains, we record a significant current flow through the ohmic contacts in the vertical direction of . The Schottky barrier diodes and the -heterojunctions exhibit rectification ratios of up to seven orders of magnitude. Room temperature current–voltage characteristics of diode ensembles as well as temperature-dependent measurements for selected Pt-based diodes reveal a mean barrier height of eV and ideality factors down to .
A ternary, orthorhombic κ-(AlxGa1−x)2O3 thin film was synthesized by combinatorial pulsed laser deposition on a 2 in. in diameter c-sapphire substrate with a composition gradient. Structural, morphological, and optical properties were studied as a function of the alloy composition. The thin film crystallized in the orthorhombic polymorph for Al contents of 0.07 ≤ x ≤ 0.46, enabling bandgap engineering from 5.03 eV to 5.85 eV. The direct optical bandgap and the c-lattice constant, as well, show a linear dependence on the cation composition. XRD measurements, especially 2θ-ω- and ϕ-scans, revealed the growth of κ-(AlxGa1−x)2O3 in [001]-direction and in three rotational domains. The surface morphology was investigated by atomic force microscopy and reveals root mean square surface roughnesses below 1 nm. Furthermore, the dielectric function (DF) and the refractive index, determined by spectroscopic ellipsometry, were investigated in dependence on the Al content. Certain features of the DF show a blue shift with increasing Al concentration.