21 September 2024 in Journal of the American Chemical Society
A limiting factor to the efficiency of water Oxygen Evolution Reaction (OER) in metal oxide nanoparticle photocatalysts is the rapid recombination of holes and electrons. Facet-engineering can effectively improve charge separation and, consequently, OER efficiency. However, the kinetics behind this improvement remain poorly understood. This study utilizes photoinduced absorption spectroscopy to investigate the charge yield and kinetics in facet-engineered BiVO4 (F-BiVO4) compared to a non-faceted sample (NF-BiVO4) under operando conditions. A significant influence of preillumination on hole accumulation is observed, linked to the saturation and, thus, passivation of deep and inactive hole traps on the BiVO4 surface. In DI-water, F-BiVO4 shows a 10-fold increase in charge accumulation (∼5 mΔOD) compared to NF-BiVO4 (∼0.5 mΔOD), indicating improved charge separation and stabilization. With the addition of Fe(NO3)3, an efficient electron acceptor, F-BiVO4 demonstrates a 30-fold increase in the accumulation of long-lived holes (∼45 mΔOD), compared to NF-BiVO4 (∼1.5 mΔOD) and an increased half-time, from 2 to 10 s. Based on a simple kinetic model, this increase in hole accumulation suggests that facet-engineering causes at least a 50-100 meV increase in band bending in BiVO4 particles, thereby stabilizing surface holes. This energetic stabilization/loss results in a retardation of OER relative to NF-BiVO4. This slower catalysis is, however, offset by the observed increase in density and lifetime of photoaccumulated holes. Overall, this work quantifies how surface faceting can impact the kinetics of long-lived charge accumulation on metal oxide photocatalysts, highlighting the trade-off between lifetime gain and energetic loss critical to optimizing photocatalytic efficiency.
24 October 2024 in ACS Catalysis
This study examines the kinetic origins of the temperature dependence of photoelectrochemical water oxidation on nanostructured titania photoanodes. We observe that the photocurrent is enhanced at 50 °C relative to 20 °C, with this enhancement being most pronounced (by up to 70%) at low anodic potentials (<+0.6 V vs RHE). Over this low potential range, the photocurrent magnitude is largely determined by kinetic competition between water oxidation catalysis (WOC) and recombination between surface holes and bulk electrons (back electron-hole recombination, BER). We quantify the BER process by transient photocurrent analyses under pulsed irradiation. Remarkably, we find that the kinetics of BER (∼90 ms half-time) are independent of temperature. In contrast, the kinetics of WOC, determined from the analysis of the photoinduced absorption of accumulated surface holes, are found to accelerate up to 2-fold at 50 °C relative to 20 °C. We conclude that the enhanced photocurrent densities observed in the low-applied potential region result primarily from the accelerated WOC, reducing losses due to the competing BER pathway. At higher applied potentials (>+0.6 V vs RHE), a smaller (∼10%) enhancement in photocurrent density is observed at 50 °C relative to 20 °C. Photoinduced absorption studies, correlated with studies using triethanolamine as a hole scavenger, indicate that this more modest enhancement at anodic potentials primarily results from an enhanced charge separation efficiency. We conclude by discussing the implications of these results for the practical application of photoanodic WOC under solar irradiation, influenced by these temperature-independent and -dependent underlying kinetic processes.
29 January 2026 in Journal of the American Chemical Society
Despite its central role in photoelectrochemical (PEC) water splitting, the mechanistic pathway of water oxidation on metal oxides remains unresolved, with population-based and Butler-Volmer (BV) models offering distinct views on how surface valence band holes drive the reaction. Here, we bring together these two perspectives by combining operando photoinduced absorption (PIA) spectroscopy with photocurrent analyses on α-Fe2O3 (hematite) photoanodes as a function of light intensity. We find a crossover from population-controlled, rate law water oxidation at low hole densities to a BV-like, potential driven regime at high densities, triggered by band edge unpinning once surface M-OH species are fully oxidized, and excess holes accumulate without compensation. This mechanistic transition unifies competing models of interfacial charge transfer and reveals design principles for optimizing water oxidation in metal oxide photoelectrodes.
30 July 2025 in The Journal of Physical Chemistry C