This study experimentally analyses the thermal behavior of different paint coatings applied to common building envelopes under winter conditions. The aim is to evaluate their influence on heat transfer. Nine airtight cubic prototypes with 50 cm sides were constructed using three representative support materials: self-protected bituminous membrane, steel metal sheet, and ceramic tile. For each material, three configurations were tested: uncoated, coated with a high-performance white acrylic paint, and coated with a high-performance white coating (Q+TERMIK). Measurements were carried out under real outdoor exposure during a typical winter day in Valencia (Spain). The methodology combined infrared thermography to record the external surface temperature with internal sensors to monitor the thermal evolution inside the prototypes. The results show that the application of white coatings significantly reduces the external surface temperature even under winter solar radiation conditions. The greatest differences were observed in materials with low thermal inertia, particularly the metal sheet, where the high-performance white coating achieved the lowest surface temperature values, showing a 13.75% reduction compared to standard solutions. In internal analysis, the painted prototypes exhibited smoother thermal curves, lower thermal amplitude, and reduced peaks associated with direct solar radiation. Thermal amplitude was reduced by up to 8.4 °C (31.8%) in the metal prototype and 7.4 °C (25.9%) in the bituminous membrane prototype. This behavior implies a lower rate of heat exchange with the exterior and greater stability of the indoor environment. It is therefore concluded that reflective coatings are not only effective in summer for limiting overheating, but also contribute in winter to improving thermal stability, constituting a passive energy-efficiency strategy with favorable performance throughout the year.