24 December 2020 in Chemical Reviews
24 November 2017 in Nature Communications
Magnesium batteries appear a viable alternative to overcome the safety and energy density limitations faced by current lithium-ion technology. The development of a competitive magnesium battery is plagued by the existing notion of poor magnesium mobility in solids. Here we demonstrate by using ab initio calculations, nuclear magnetic resonance, and impedance spectroscopy measurements that substantial magnesium ion mobility can indeed be achieved in close-packed frameworks (~ 0.01–0.1 mS cm–1 at 298 K), specifically in the magnesium scandium selenide spinel. Our theoretical predictions also indicate that high magnesium ion mobility is possible in other chalcogenide spinels, opening the door for the realization of other magnesium solid ionic conductors and the eventual development of an all-solid-state magnesium battery.
3 December 2019 in Advanced Energy Materials
Low active material loading in the composite electrode of all‐solid‐state batteries (SSBs) is one of the main reasons for the low energy density in current SSBs. In this work, it is demonstrated with both modeling and experiments that in the regime of high cathode loading, the utilization of cathode material in the solid‐state composite is highly dependent on the particle size ratio of the cathode to the solid‐state conductor. The modeling, confirmed by experimental data, shows that higher cathode loading and therefore an increased energy density can be achieved by increasing the ratio of the cathode to conductor particle size. These results are consistent with ionic percolation being the limiting factor in cold‐pressed solid‐state cathode materials and provide specific guidelines on how to improve the energy density of composite cathodes for solid‐state batteries. By reducing solid electrolyte particle size and increasing the cathode active material particle size, over 50 vol% cathode active material loading with high cathode utilization is able to be experimentally achieved, demonstrating that a commercially‐relevant, energy‐dense cathode composite is achievable through simple mixing and pressing method.
20 August 2020 in Journal of Materials Chemistry A
In this work, we visualize and quantify the microstructure evolution in the composite electrode after solid-state battery (SSB) cycling. The observed severe mechanical degradation highlights the importance of mechanical considerations in SSB design.
29 August 2018 in Chemistry of Materials
25 February 2019 in ACS Energy Letters
Understanding the structural transformation at the surface of Ni-rich layered compounds is of particular importance for improving the performance of these cathode materials. In this paper we identify the surface phases using first principles based kinetic Monte Carlo simulations. We show that slow kinetics precludes the conventional Li0.5NiO2 spinel to form from its layered parent phase at room temperature. Instead, we suggest that densified phases of the types Ni0.25NiO2 and Ni0.5NiO2 can form by Ni back diffusion from the surface owing to oxygen loss at highly charged states. Our conclusion is supported by the good agreement between the simulated STEM images and diffraction patterns and previously reported experimental data. While these phases can be mistaken for spinel and rock salt structures in STEM they are noticeably different from these common structure types. We believe that these results clarify a long-standing puzzle about the nature of surface phases on this important class of battery materials.