Minking K. Chyu

Minking K. Chyu

Auto-generated profile, based on publicly available information

Minking K. Chyu

Department of Mechanical Engineering and Material Science, University of Pittsburgh, Pittsburgh, PA 15261

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 May 2013 in Journal of Thermal Science and Engineering Applications
Verified
Journal Article
Closed access
PDF file
MCMinking K. Chyu
Minking K. Chyu
SSSin Chien Siw
Sin Chien Siw

5 June 2012 in Journal of Heat Transfer
Verified
Journal Article
Closed access
PDF file
SSSin Chien Siw
Sin Chien Siw
MCMinking K. Chyu
Minking K. Chyu
TSTom I.-P. Shih
Tom I.-P. Shih
MAMary Anne Alvin
Mary Anne Alvin

12 May 2020 in Journal of Turbomachinery
Verified
Journal Article
Closed access
PDF file
SPSarwesh Parbat
Sarwesh Parbat
ZMZheng Min
Zheng Min
Li YangLi Yang
Li Yang
MCMinking Chyu
Minking Chyu

1 January 2012 in Numerical Heat Transfer, Part A: Applications
Verified
Journal Article
Closed access
BRB. V. K. Reddy
B. V. K. Reddy
MBMatthew Barry
Matthew Barry
JLJohn Li
John Li
MCMinking K. Chyu
Minking K. Chyu
Thermoelectric elements made of semiconductor plates laminated onto a highly electrical and thermally conductive inter-connector with a flow channel configuration can be treated as an integrated thermoelectric device (iTED). An element constructed with bulk crystalline n- and p-type (Bismuth-Telluride) semiconducting materials and copper as a conducting material is considered. In this study, the thermoelectric performance of such an element using fluid-thermoelectric coupled field numerical methods has been investigated. The iTED is subjected to constant cold temperature at the bottom and top surfaces, while the inter-connector channel walls are exposed to hot fluid flow; the remaining surfaces are kept adiabatic. The performance of the iTED element is studied in terms of heat input Q h , power output P 0, conversion efficiency η, produced electric current and Ohmic and Seebeck voltages for different load resistances, inlet hot fluid temperatures T in , semiconductor material heights d, and flow rates Re. For fixed T in and Re, an optimum η is shown at a load resistance which is slightly lesser than total internal resistance value. An increase in T in results in an enhancement in P 0 and η; however, it has a minimal effect on the variation of optimum load resistance. At higher T in values, the increment in load resistance showed a significant change in the heat input values. Both semiconductor material height and fluid flow rate had a prominent effect on iTED performance. The P 0 and η are increased nearly three-fold and 1.6 times, respectively, at Re = 500 in comparison to Re = 100. Further, when d = 5 mm, approximately 1.7 times in P 0 and 3.3 times in η are achieved compared to d = 1 mm values. It is recommended that for an accurate modeling, design and optimization of state-of-the-art TED with flow channels be carried out using multiphysics coupling field simulations.

11 February 2013 in Journal of Heat Transfer
Verified
Journal Article
Closed access
PDF file
BRB. V. K. Reddy
B. V. K. Reddy
MBMatthew Barry
Matthew Barry
JLJohn Li
John Li
MCMinking K. Chyu
Minking K. Chyu

11 January 2012 in Journal of Heat Transfer
Verified
Journal Article
Closed access
PDF file
MCMinking K. Chyu
Minking K. Chyu