17 December 2018 in IEEE Transactions on Signal Processing
We address the waveform design problem for multiple-input multiple-output (MIMO) radar in spectrally crowded environments. We exploit the mutual information between the target reflections and the target responses as the design metric. To tackle the associated non-convex optimization problem, we propose an algorithm based on first-order Taylor series approximation as well as minorization-maximization (MM)-based algorithms to design the spectrally constrained waveforms. Interestingly, for some scenarios, we can synthesize the globally optimal (spectrally constrained) waveforms with the maximum mutual information. We also show that, through intelligent waveform design, MIMO radar can coexist more efficiently with other communication systems occupying the same spectrum, while suffering from insignificant mutual information losses.
1 May 2008 in The Journal of the Acoustical Society of America
Using microphone arrays for estimating source locations and strengths has become common practice in aeroacoustic applications. The classical delay-and-sum approach suffers from low resolution and high sidelobes and the resulting beamforming maps are difficult to interpret. The deconvolution approach for the mapping of acoustic sources (DAMAS) deconvolution algorithm recovers the actual source levels from the contaminated delay-and-sum results by defining an inverse problem that can be represented as a linear system of equations. In this paper, the deconvolution problem is carried onto the sparse signal representation area and a sparsity constrained deconvolution approach (SC-DAMAS) is presented for solving the DAMAS inverse problem. A sparsity preserving covariance matrix fitting approach (CMF) is also presented to overcome the drawbacks of the DAMAS inverse problem. The proposed algorithms are convex optimization problems. Our simulations show that CMF and SC-DAMAS outperform DAMAS and as the noise in the measurements increases, CMF works better than both DAMAS and SC-DAMAS. It is observed that the proposed algorithms converge faster than DAMAS. A modification to SC-DAMAS is also provided which makes it significantly faster than DAMAS and CMF. For the correlated source case, the CMF-C algorithm is proposed and compared with DAMAS-C. Improvements in performance are obtained similar to the uncorrelated case.
18 June 2018 in IEEE Transactions on Signal Processing
This paper addresses the problem of Minimum Peak Sidelobe Transmit Beampattern (MPSTB) design for colocated MIMO radar systems. Two new methods are proposed to achieve it via designing Constant Modulus (CM) waveforms directly. One is to maximize the ratio of the Minimum Mainlobe Level (MML) to the Peak Sidelobe Level (PSL) without specifying pattern masks. Another is to minimize PSL under the mainlobe ripple and unspecified waveform modulus constraints. The resultant optimization problems are difficult to solve due to the coupled numerator and denominator of the Quadratic Fractional Programming (QFP) problem formulation in the former and double-sided quadratic constraints and unknown waveform modulus in the latter. For the former, we decouple the numerator and denominator by equivalent transform and introduction of boundary-type auxiliary variables in order that feasible methods are derived to tackle them independently and efficiently. For the latter, we simplify the coupled double-sided quadratic constraints on the same waveform vector into those on different single auxiliary variables to tackle the corresponding nonconvex optimization problem. Numerical examples show that the proposed algorithms can attain sufficient low peak sidelobe beampattern levels under the CM constraints.
1 October 2014 in Digital Signal Processing
2 July 2018 in IEEE Transactions on Aerospace and Electronic Systems
This paper deals with the robust waveform design of Multiple-Input Multiple-Output (MIMO) radar to improve target detectability embedded in signal-dependent interferences. Two iterative algorithms with ensuring convergence properties are introduced to maximize the worst case Signal-to-Interferenceplus-Noise Ratio (SINR) over steering matrix mismatches under the constant modulus and similarity constraints. Each iteration of the proposed algorithms splits the high dimensional problem into multiple one dimensional problems, to which the optimal solutions can be found in polynomial times. Numerical examples are provided to assess the capabilities of the proposed techniques in comparison with the existing methods in terms of the SINR and the computational times for both the continuous and discrete phase cases of the probing signal
2 September 2019 in IEEE Transactions on Signal Processing
Target parameter estimation in active sensing, and particularly radar signal processing, is a long-standing problem that has been studied extensively. In this paper, we propose a novel approach for target parameter estimation in cases where one-bit analog-to-digital-converters (ADCs), also known as signal comparators with time-varying thresholds, are employed to sample the received radar signal instead of high-resolution ADCs. The considered problem has potential applications in the design of inexpensive radar and sensing devices in civilian applications, and can likely pave the way for future radar systems employing low-resolution ADCs for faster sampling and high-resolution target determination. We formulate the target estimation as a multivariate weighted-least-squares optimization problem that can be solved in a cyclic manner. Numerical results are provided to exhibit the effectiveness of the proposed algorithms.