11 November 2019 in Advanced Materials
10 November 2014 in Applied Physics Letters
Simultaneously achieving drag reduction and capillary evaporation enhancement is highly desired but challenging because of the trade-off between two distinct hydrophobic and hydrophilic wettabilities. Here, we report a strategy to synthesize nanoscale biphilic surfaces to endow exceptional drag reduction through creating a unique slip boundary condition and fast capillary wetting by inducing nanoscopic hydrophilic areas. The biphilic nanoporous surfaces are synthesized by decorating hydrophilic functional groups on hydrophobic pristine multiwalled carbon nanotubes. We demonstrate that the carbon nanotube-enabled biphilic nanoporous surfaces lead to a 63.1% reduction of the friction coefficient, a 61.7% wetting speed improvement, and up to 158.6% enhancement of capillary evaporation heat transfer coefficient. A peak evaporation heat transfer coefficient of 21.2 W/(cm2·K) is achieved on the biphilic surfaces in a vertical direction.
1 September 2021 in Science Bulletin
18 June 2018 in Applied Physics Letters
Surface structure and intrinsic wettability are both important for boiling heat transfer. While superhydrophilic micro, nano, and hierarchical surfaces are widely used for boiling enhancement, in which the surface structure and intrinsic wettability usually couple together. This study aims to decouple their influences on boiling heat transfer. Copper meshes are utilized as the microporous structures, and conformal superhydrophilic films of TiO2 are deposited by atomic layer deposition (ALD). Although ALD coatings for boiling have been done on flat surfaces, this study separates the influence of surface structure from that of intrinsic wettability on a three-dimensional microporous surface. By comparing two and four layer meshes, we show that the surface structure has no obvious influence on the critical heat flux (CHF), but can significantly enhance the heat transfer coefficient (HTC). The intrinsic superhydrophilicity dramatically increases the CHF due to the fast rewetting of dryout regions. Our conclusion is that fast rewetting is critical to increase the CHF, while large surface areas are vital to enhance the HTC.
1 February 2022 in Carbon
27 May 2021 in Scientific Reports
High performance miniaturized electronic devices require enhanced, compact and reliable thermal management system. As an efficient compact space cooling technique, flow boiling in microchannels has recently gained wide acceptance. However, weak buoyancy effects and microgravity in avionics and numerous space systems operations hinder the performance of flow boiling microchannel thermal management system due to poor bubble departure capacity and unfavorable development of flow regimes. Here we report the flow boiling silicon nanowires (SiNWs) microchannels which can favorably regulate two-phase flow regimes by enhancing explosive boiling, minimizing bubble departure diameter, and smoothing flow regime transition. Extensive experimental investigations along with high speed visualizations are performed. The experiments are performed with the dielectric fluid HFE-7100 in a forced convection loop for wide range of heat and mass fluxes. High speed flow visualizations have been employed at up to 70 k frames per second (fps) to understand the boiling mechanism in terms of bubble dynamics, flow patterns, and flow regime developments for SiNWs microchannels. These studies show that SiNWs reduce intermittent flow regimes (slug/churn), improve rewetting and maintain thin liquid film at wall. Therefore, flow boiling in SiNW microchannels is promising to thermal management owing to its high heat transfer rate with low pressure drop and negligible microgravity sensitivity.