We propose a dual circularly polarized (CP) substrate integrated waveguide (SIW) cavity-backed antenna with wide axial ratio (AR) beamwidth, which can generate the right-hand CP (RHCP) or left-hand CP (LHCP) radiation through exciting different ports. Dual CP radiations are accomplished by an SIW directional coupler (DC) in the bottom layer, which provides the desired amplitude and phase conditions for two orthogonal slots. By superposing phase centers of linearly polarized (LP) electric field elements, the proposed antenna achieves a good performance of 3 dB AR beamwidth of 165° in the desired azimuth cut plane. Furthermore, an eight-element dual CP linear phased array with a wide-angle beam scanning ability is comprised by this antenna prototype. Numerical and measured results show that the array antenna can scan its main lobe from – 59° to 58°. In general, the proposed antenna array fed by the SIW structure satisfies the requirement of a multipolarization wireless communication system for low profile, simple structure, and easy integration with planar circuits.
12 October 2021 in IEEE Transactions on Antennas and Propagation
We propose to suppress high-power microwave pulses (HPMPs) using nonlinear dispersion and filtering natures of spoof surface plasmon polaritons (SSPPs). Frequency components of a short HPMP are distributed in time domain due to different group velocities and partly cutoff on SSPP transmission lines (TLs), leading to peak suppression of HPMP. To illustrate the protection mechanism in real microwave engineering, an SSPP mono-pulse antenna is designed. Sum and difference beam functions of the antenna are demonstrated by both simulations and experiments. For easy comparison, a microstrip mono-pulse antenna is also fabricated. HPMP incidences from the main lobe directions of the sum beam and difference beam are considered. Compared to the microstrip antenna, obvious suppression of HPMPs is observed in the SSPP mono-pulse antenna in different cases, which verifies the better performance to prevent HPMP damages by SSPPs. The proposed technology to suppress HPMPs by using SSPPs can find wide applications in radar and communication systems in the electronic warfare environment.
20 December 2022 in IEEE Transactions on Microwave Theory and Techniques
Reconfigurability of dispersion properties of spoof surface plasmon polaritons (SSPPs) have been realized by loading tunable elements such as varactors and p-i-n diodes. However, the parasitic resistance of tunable elements will lead to transmission loss of SSPPs, which still lacks investigation. In this article, we propose to comprehensively answer three critical questions in this area: 1) how to analyze the loss of reconfigurable SSPPs; 2) how to reduce the loss of reconfigurable SSPPs; and 3) how to utilize the loss of reconfigurable SSPPs. For the first question, the complex characteristic impedance of reconfigurable SSPPs is theoretically obtained, which indicates the mechanism of the enhanced loss in reconfigurable SSPPs. For the second question, a low-loss reconfigurable SSPP structure loading parallel varactors is proposed to reduce and reconfigure the loss of reconfigurable SSPPs. For the third question, a multifunctional 2-unit antenna array is designed and tested using a feeding network composed of the loss-reconfigurable SSPPs. Experimental results demonstrate that two functions of sum-difference beam forming and amplitude modulation are achieved by the single sample. Thus the technique of loss reconfiguration in SSPPs may find wide applications in efficiency-sensitive circuits and smart microwave systems in the future.
7 July 2021 in Journal of Physics D: Applied Physics
Frequency-dependent characteristic impedance extraction and compact excitation of spoof surface plasmon polariton (SSPP) waveguides are achieved in this work. The behavior of SSPP waveguides cannot be directly described using the transmission-line model due to the non-transverse electromagnetic modes. By investigating the near-field distribution of a typical SSPP waveguide, we find a special position where the field component in the longitudinal direction is nearly equal to zero, and the reflection is completely caused by impedance mismatch rather than mode mismatch. Then, the characteristic impedance curve of the SSPP waveguide is extracted. Based on the obtained characteristic impedance and the special excitation position, transition between the microstrip and SSPP waveguide in the desired frequency bands can be achieved without using an additional gradient-corrugation transition structure. Compared to the conventional gradient-corrugation strategy, the proposed transition has a much more compact size and better transition performance. Meanwhile, the accuracy of the proposed method is not impacted by the internal discontinuities and local couplings of typical or atypical SSPP waveguides, which is a complicated problem in other methods. The simulated and measured results demonstrate the validity of the presented method. Hence, the characteristic impedance extracted by the presented method is accurate and makes compact transformation and systematic integration of SSPP waveguides more practicable.
25 October 2022 in IEEE Transactions on Antennas and Propagation
We present a method of designing pattern reconfigurable Yagi antenna based on active corrugated strip line (ACSL) technology. A conventional dipole is used as a driven element and a pair of ACSLs in different states are set on both sides of the dipole symmetrically. The ACSLs in different states have different average phase constants (β ave ), where the ACSL with a lower β ave serves as a director, while the other serves as a reflector. By changing the β ave of the ACSLs, a front-to-back pattern reconfigurable Yagi antenna is realized. A prototype of the proposed antenna working at the center frequency of 2.4GHz was fabricated and measured to validate the predicted performance. The fabricated antenna has a compact size (0.42λ 0 × 0.42λ 0 , λ 0 is the wavelength in space) and low profile (0.004λ 0 ). The measured -10dB impedance bandwidth and the gain of the antenna are 8.3% and 6.2dBi (at 2.4GHz), respectively.