Electric discharge machining is an essential modern manufacturing process employed to machine porous sintered metals. The sintered 316L porous stainless steel (PSS) components are widely used in diverse engineering domains, as interconnected pores are present. The PSS material has excellent lightweight and damping properties and superior mechanical and metallurgical properties. However, conventional machining techniques are not suitable for porous metals machining. Such techniques tend to block the micro-pores, resulting in a decrease in porous materials’ breathability. Thus, the EDM process is an effective technique for porous metal machining. The input process parameters selected in this study are peak current , pulse on time , voltage , flushing pressure , and porosity. The response parameters selected are material removal rate (MRR) and tool wear rate (TWR). The present work aims to obtain optimum machining process parameters in the EDM of porous sintered SS316L using two meta-heuristic optimization techniques, i.e., Teaching Learning-Based Optimization (TLBO) and Particle Swarm Optimization (PSO) algorithms, to maximize the MRR and minimize the TWR values. In the case of PSS having a 12.60% porosity value, PSO and TLBO algorithms give same optimum machining parameters. However, for PSS having an 18.85% porosity value, the PSO algorithm improves by about 5.25% in MRR and by 5.63% in TWR over the TLBO. In the case of PSS having a 31.11% porosity value, the PSO algorithm improves about 3.73% in MRR and 6.46% in TWR over the TLBO. The PSO algorithm is found to be consistent and to converge more quickly, taking minimal computational time and effort compared to the TLBO algorithm. The present study’s findings contribute valuable information in regulating the EDM performance in machining porous SS316L.
10 January 2020 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
In the present study the effects of machining parameters on the average surface roughness (Ra) in electrical discharge turning (EDT) is investigated. EDT is a new machining process in which a rotary spindle is added to a conventional die-sinking EDM machine in order to produce cylindrical components. In this method a new process parameter (spindle rotation) along with pulse on time and current is introduced to study its effect on Ra. This has been done by means of full factorial design (21 × 32) of experiments. A mathematical model has been developed for Ra by regression analysis and factor effects were analyzed using analysis of variance (ANOVA). Signal-to-noise ratio analysis is used to find the optimal condition.
In this research, single pass cutting of HCHC (High Chromium High Carbon) die steel AISI D3 Grade has been used where material removal rate (MRR) and surface roughness (SR) are of primary importance. In general, achieving a high level cutting speed with a better surface finish is extremely difficult task because in wire cut electric discharge machining (WEDM), no particular parametric combination is expected to yield simultaneously in the best MRR and the best SR. Hence it can be considered as multi objective optimization problem. This research presents an attempt at multi objective optimization of the process parametric combinations by modeling the process using artificial neural network (ANN). A feed forward back propagation neural network based on matrix experimental design is developed to model the WEDM process. Based on the developed model, different response parameters are calculated for various input parameter setting. Finally they are compared to find out optimal combination of machining parameter setting. Electronica make EZEECUT PLUS model has been used for experimentation and a methodology has been suggested to determine the optimal combination of control parameters in WEDM. Research findings in the area of machining HCHC die steel through WEDM process will open up a new horizon and will certainly solve various challenging problems faced by the engineers and die makers in the field of modern manufacturing industry.