31 October 2014 in Applied Mechanics and Materials
MSMuhammad Mohamed Salleh
+1
Structural vibration is undesirable, wasting energy and possibly leading to excessive deflections and structure and machine’s failure. In order to reduce structural vibration, one of the common way is considering vibration absorber system attach to the structure. In this study, a vibration absorber is developed in a small scale size. The host structure selected for the study is a fixed-fixed ends beam. The effectiveness of vibration absorbers attached to a beam is investigated through experimental study. In prior to experiment, a finite element analysis of Solidworks® and analytical equations of Matlab® are produced in order to determine the structural dynamic response of the beam, such as the natural frequency and mode shapes. The preliminary results of finite element analysis demonstrate that the first five natural frequency of fixed-fixed end beam are 17Hz, 46Hz, 90Hz, 149Hz and 224Hz, and these results are in agreement with the beam’s analytical equations. However, there are slight discrepancies in experiment result due to noise and error occurred during the setup. In the later stage, the experimental works of beam are performed with attached vibration absorber. Result shows that the attachment of vibration absorber produces better outcome, which is about 45% vibration reduction. It is expected that by adding more vibration absorber to the structure, the vibration attenuation can significant.
15 September 2019 in International Journal of Integrated Engineering
MMMuhamad Zariq Imran Abdul Manap
Muhamad Zariq Imran Abdul Manap
+2
30 May 2019 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
10 April 2013 in Applied Mechanics and Materials
AZAhmad Mujahid Ahmad Zaidi
Ahmad Mujahid Ahmad Zaidi
In the present work polyurethane foams containing various content loadings of kenaf fiber and recycled tire rubber particulates were prepared and studied, with the objective of developing alternative composite rigid foams. The influence of the filler content on the foam microstructure and its physical and mechanical behavior has been studied for three different polyurethane resin densities. Microstructural observation on fracture surface of composites was carried out using scanning electron microscopy. It has shown closed spherical cells with reduced size when the fillers are added. Nevertheless, the incorporation of kenaf fiber and recycled tire rubber particulates that refined at 80 mesh led to higher mechanical properties than that unfilled polyurethane foam. A 6% filler content loading exhibited the optimum compression stress and compression modulus, while further increase of filler content loading resulted in decline in mechanical behavior. The presence of larger filler content deteriorated the polyurethane system cellular structure and lead to poor composites strength. Overall, the use of kenaf fiber and recycled tire rubber particulates gives composite foams with comparable mechanical behavior for the studied filler reinforcement level.
17 July 2014 in MATEC Web of Conferences
MSMuhammad Mohamed Salleh
+1
20 September 2019 in Lecture Notes in Mechanical Engineering
MJMohamad Zhairul Iqumal Jumari
Mohamad Zhairul Iqumal Jumari
ENEngku Mohd Nasri Engku Nasir
Engku Mohd Nasri Engku Nasir
+3