1 November 2019 in Journal of Shoulder and Elbow Surgery
1 February 2022 in The Spine Journal
19 March 2021 in World Neurosurgery
24 February 2020 in JSES International
Concomitant biceps tendon pathology is often present in patients undergoing rotator cuff repair (RCR). Management of biceps pathology has been reported to influence outcomes of RCR; however, the impact on the pace of recovery remains unclear. The purpose of this study was to analyze the effects of simultaneous RCR with biceps tenodesis (RCR-BT) on time to achieve maximum improvement and recovery speed for pain and function. A retrospective review of 535 patients who underwent primary RCR for full-thickness tears. Patients treated with simultaneous RCR-BT were compared with RCR-only. Outcome measures and motion were recorded at preoperative routine postoperative intervals. Plateau in maximal improvement and recovery speed were analyzed for both pain and functional recovery. Baseline American Shoulder and Elbow Surgeons Standardized Shoulder Assessment Form (ASES) function was significantly lower for the RCR-BT cohort (20.5) compared with RCR-only (23.9; P = .008). For visual analog scale (VAS) pain and measured motion, the plateau in maximal improvement occurred at 6 months for RCR-BT compared with 12 months for the RCR-only group. The remainder of the patient-reported outcome measures took 12 months to achieve a plateau in maximal improvement. At 3 months, 79% of improvement in pain and 42%-49% of functional improvement was achieved in the RCR-BT cohort. Similarly, at 3 months, the RCR-only cohort achieved 73% of pain improvement and 36%-57% of functional improvement at 3 months. Patients requiring RCR with simultaneous biceps tenodesis have lower baseline ASES function and earlier postoperative plateaus in pain relief and motion improvement following surgery. Nonetheless, the speed of recovery was not influenced by the biceps tenodesis.
1 July 2021 in Journal of Orthopaedics
1 January 2020 in JBJS Open Access
Background: Axillary radiographs traditionally have been considered sufficient to identify concentric glenoid wear in osteoarthritic shoulders; however, with variable glenoid wear patterns, assessment with use of computed tomography (CT) has been recommended. The purpose of the present study was to compare the use of axillary radiographs and mid-glenoid axial CT scans to identify glenoid wear. Methods: Preoperative axillary radiographs and mid-glenoid axial CT scans for 330 patients who underwent anatomic total shoulder arthroplasty were reviewed. Five independent examiners with differing levels of experience characterized the glenoid morphology as either concentric or eccentric. The morphologies determined with use of axillary radiographs and CT scans were assessed for correlation, and both intraobserver and interobserver consistency were calculated. Results: Concentric wear identified with use of radiographs was confirmed with use of CT scans in an average of 61% of cases (range, 53% to 76%). Intraobserver consistency averaged 75% for radiographs and 73% for CT scans. There was significant interobserver consistency, as higher levels of training corresponded with greater consistency between imaging analyses (p < 0.001). The most senior observer identified the highest proportion of concentric wear on radiographs (p < 0.001), showed the greatest consistency between attempts when using CT (p < 0.001), and had the greatest agreement of radiographs and CT evaluating glenoid morphology (p < 0.001). Conclusions: For the experienced shoulder surgeon, concentric glenoid wear identified on axillary radiographs will appear concentric on 2-dimensional CT in approximately 75% of cases. Obtaining a CT scan to confirm glenoid wear patterns most greatly benefits less-experienced surgeons. Across all levels of experience, axillary radiographs and single-slice, mid-glenoid CT scans appear insufficient for consistently predicting wear patterns. Level of Evidence: Diagnostic Level III. See Instructions for Authors for a complete description of levels of evidence.