1 May 2023 in Tikrit Journal of Engineering Sciences
Seepage is a dangerous phenomenon under hydraulic structures and the main cause of failure and damage to dams when neglected and not processed. This study evaluates the numerical effects of the sheet piles' quantity, depth, and spacing beneath a concrete dam with isotropic and homogenous foundations on the seepage rate, pressure head, and exit gradient. The solutions were obtained using SEEP/W code in GeoStudio software 2018 for three configurations using single, double, and triple sheet piles. In addition, SLIDE software 6.02 was examined using single and double sheet piles. Dimensional analysis was applied to draw the dimensionless variables that affect the seepage rate and exit gradient, and all tests were repeated for three different sheet pile depths and distances from the heel of the dam. The findings showed that the seepage rate in all studied configurations reduced when sheet pile depth increased. The position of the sheet pile from the dam's toe significantly decreased the seepage rate in cases using single and double sheet piles, while in cases using three-sheet piles, the position of the middle sheet pile insignificant decreased seepage. It was recognized that when using a single sheet pile, the drop in pressure head increased with depths when the sheet pile was located at the heel and middle of the dam. In addition, in the case of a single sheet pile at the toe or using two and three-sheet piles, the pressure drop decreased as the depths increased. Also, the results showed that the middle sheet pile location in the case of three sheet piles slightly affected pressure reduction. Furthermore, the results showed that using two and three-sheet piles was more effective than using a single one in reducing the exit gradient, while the position of the middle one in the case of using three-sheet piles was insignificant. A nonlinear empirical equation was developed using SPSS 22 program, and the comparison of the seepage rate measured by SEEP/W and SLIDE software versus its quantity calculated from empirical equations showed a good agreement as the determinations (R2) coefficients were equal to 0.9779 and 0.9928, respectively.
30 December 2021 in Polytechnic Journal
A Labyrinth weir is a type of nonlinear weir folded in plan-view, with the ability to pass a large flow at low heads due to an increase in the effective length of the weir crest for a given channel width. The discharge coefficients (Cd) were experimentally determined for both semicircular and triangular labyrinth weirs of varying sidewall angles (α) under free-flow conditions using eight physical models. Dimensional analyses are conducted using the Buckingham π theorem to find the dependent and non-dependent variables. A nonlinear empirical equation was developed using (Statistical Package for the Social Sciences 22) software. The findings show that the discharge coefficient decreases with the increase of headwater to (Ht/P) for both types of labyrinth weir with different plan forms. It is found that the efficiency of the semicircular and triangular labyrinth is higher than linear weir for (Ht/P ≤ 0.45) and decreases with increasing the value of (Ht/P) due to interference of flow between the layers in downstream. The obtained results revealed that the discharge coefficient (Cd) values obtained empirically using multivariable power regression and 5th degree polynomial equations considerably agree with the experimental data, for both of the semicircular and triangular labyrinth weirs. Furthermore, the correlation coefficient R2was (0.9951) and (0.9637) using 5th degree polynomial equation, and their values were (0.9643) and (0.9274) using multivariable power regression equation for both semicircular and triangular labyrinth weir models, respectively. The results in the present study compared quite well with the predicted results of the proposed equations obtained by other investigators.