Efficiency from hole-selective contacts: Perovskite/silicon tandem solar cells must stabilize a perovskite material with a wide bandgap and also maintain efficient charge carrier transport. Al-Ashouri et al. stabilized a perovskite with a 1.68–electron volt bandgap with a self-assembled monolayer that acted as an efficient hole-selective contact that minimizes nonradiative carrier recombination. In air without encapsulation, a tandem silicon cell retained 95% of its initial power conversion efficiency of 29% after 300 hours of operation. Science , this issue p. 1300
Stable perovskites with ionic salts: Ionic liquids have been shown to stabilize organic-inorganic perovskite solar cells with metal oxide carrier-transport layers, but they are incompatible with more readily processible organic analogs. Lin et al. found that an ionic solid, a piperidinium salt, enhanced the efficiency of positive-intrinsic-negative layered perovskite solar cells with organic electron and hole extraction layers. Aggressive aging testing showed that this additive retarded segregation into impurity phases and pinhole formation in the perovskite layer. Science , this issue p. 96
Improved stability and efficiency of two-terminal monolithic perovskite-silicon tandem solar cells will require reductions in recombination losses. By combining a triple-halide perovskite (1.68 electron volt bandgap) with a piperazinium iodide interfacial modification, we improved the band alignment, reduced nonradiative recombination losses, and enhanced charge extraction at the electron-selective contact. Solar cells showed open-circuit voltages of up to 1.28 volts in p-i-n single junctions and 2.00 volts in perovskite-silicon tandem solar cells. The tandem cells achieve certified power conversion efficiencies of up to 32.5%.
25.5% efficiency is demonstrated for monolithic perovskite/silicon tandem solar cell using textured foil and the impact of texture position on performance and energy yield is simulated.
Metal halide perovskites show great promise to enable highly efficient and low cost tandem solar cells when being combined with silicon. Here, we combine rear junction silicon heterojunction bottom cells with p–i–n perovskite top cells into highly efficient monolithic tandem solar cells with a certified power conversion efficiency (PCE) of 25.0%. Further improvements are reached by reducing the current mismatch of the certified device. The top contact and perovskite thickness optimization allowed increasing the JSC above 19.5 mA cm−2, enabling a remarkable tandem PCE of 26.0%, however with a slightly limited fill factor (FF). To test the dependency of the FF on the current mismatch between the sub-cells, the tandems' J–V curves are measured under various illumination spectra. Interestingly, the reduced JSC in unmatched conditions is partially compensated by an enhancement of the FF. This finding is confirmed by electrical simulations based on input parameters from reference single junction devices. The simulations reveal that especially the FF in the experiment is below the expected value and show that with improved design we could reach 29% PCE for our monolithic perovskite/silicon tandem device and 31% PCE if record perovskite and silicon cell single junctions could be combined in tandem solar cells.