This research presents the development of an intelligent controller for the helicopter turboshaft engines gas temperature, aimed at compensating for the measuring sensor’s inertial delays and optimizing transient processes. The aim is to compensate for inertial delays τ ≈ 0.025 seconds and optimize transient processes. The method is based on a double summation circuit with a channel selector, comparing signals from a thermocouple and a gas-generator rotor speed sensor, and an adaptive observer based on Pade approximation and Taylor series expansion provides a prediction of the state at t + τ. The intelligent control law includes a proportional-integral-differential structure with the coefficients γi correction via gradient descent. To refine the delay estimate, a two-layer fully connected multilayer perceptron with a SmoothReLU activation function is implemented trained on flight test data was implemented, which reduced τ to 0.016 seconds (–36 %). This module allows to approximate nonlinear relations between input features and the delay value, which ensures the control signal’s timely correction and the system’s adaptation to changing operating conditions. Modeling of the system in the Matlab Simulink environment demonstrated a significant improvement in the transient process characteristics: overshoot was reduced from 8.0 to 1.5 %, and the mode establishment time was reduced from 4.2 to 3.3 seconds. The neural network module testing showed high predicting accuracy (99.537 % with losses of 0.511 %), confirmed by the determination coefficient R2 = 0.9717. The neural network use made it possible to reduce the delay value to 0.016 seconds, which corresponds to an improvement of 36 % compared to traditional methods. The obtained results indicate a proposed technique’s high potential for improving the helicopter turboshaft engines automatic control system’s dynamic accuracy and stability.
In this paper, we propose an innovative hybrid method for the helicopter turboshaft engine's gas temperature in front of the compressor turbine, determining under rapid change conditions in operating parameters. The method is based on an adaptive neural network built on the LSTM architecture and physical and mathematical modeling implemented through a heat balance and correction using a Kalman filter combination. This approach allows us to take into account the temperature changes dynamics, compensate for the sensors’ inertia and minimize the interference impact, which significantly improves the estimate accuracy compared to traditional direct measurement methods. At the signal preprocessing stage, wavelet transform and singular spectrum analysis (SSA) are used to eliminate noise and restore missing data, which ensures the initial data is high quality for further modeling. The obtained normalized data are fed to the LSTM network input equipped with an adaptation mechanism that allows adjusting the model weights depending on changes in engine characteristics. The predicted temperature values are integrated with the physical modeling results using the Kalman filter algorithm, which provides an optimal combination of information from both models in order to achieve the lowest prediction error. The method’s experimental verification was carried out on the TV3-117 engine data installed on the Mi-8MTV helicopter. The obtained results demonstrate high predicting accuracy: the mean absolute error (MAE) was 0.34 %, the root mean square error (RMSE) was 0.45 %, and the determination coefficient (R²) reached 0.992. At the same time, the algorithm’s computational time does not exceed 55 ms, which allows using the method in real time for the engine operation’s monitoring and diagnostics. The proposed hybrid approach has proven its efficiency in the rapidly changing conditions of operating modes, providing reliable and accurate determination of the gas temperature.