We present a detailed study of the surface acoustic wave mediated quantized transport of electrons through a split-gate device containing an impurity potential defined quantum dot within the split-gate channel. A regime of quantized transport is observed at low rf powers where the surface acoustic wave amplitude is comparable to the quantum dot charging energy. In this regime resonant transport through the single-electron dot state occurs which we interpret as turnstile-like operation in which the traveling wave amplitude modulates the entrance and exit barriers of the quantum dot in a cyclic fashion at GHz frequencies. For high rf powers, where the amplitude of the surface acoustic wave is much larger than the quantum dot energies, the quantized acoustoelectric current transport shows behavior consistent with previously reported results. However, in this regime, the number of quantized current plateaus observed and the plateau widths are determined by the properties of the quantum dot, demonstrating that the microscopic detail of the potential landscape in the split-gate channel has a profound influence on the quantized acoustoelectric current transport.
We present a realization of quantized charge pumping. A lateral quantum dot is defined by metallic split gates in a GaAs/AlGaAs heterostructure. A surface acoustic wave whose wavelength is twice the dot length is used to pump single electrons through the dot at a frequency The pumped current shows a regular pattern of quantization at values over a range of gate voltage and wave amplitude settings. The observed values of the number of electrons transported per wave cycle, are determined by the number of electronic states in the quantum dot brought into resonance with the Fermi level of the electron reservoirs during the pumping cycle.
12 March 2007 in IEEE Transactions on Instrumentation and Measurement
This paper describes two systems recently developed at the National Physical Laboratory (NPL), Teddington, U.K., for the generation and measurement of dc currents in the range 100 fA to 1 nA. Both systems are based on the capacitor charging technique. One system generates known currents, and constitutes a new reference at NPL. The other was designed to meet the traceability requirements of the Ionizing Radiation sections of NPL and combines commercially available instrumentation and standards to produce a reliable stand-alone system for measuring small currents