1 April 2021 in Materials Science and Engineering: R: Reports
15 July 2020 in Journal of Materials Chemistry C
Seebeck coefficient of VFe2Al over a wide range of doping levels can be explained only with a small band-gap (Eg) range of 0.02–0.04 eV. This Eg value is also consistent with high-temperature resistivity data of nominally stoichiometric VFe2Al.
7 April 2023 in Advanced Energy Materials
Yb10MgSb9 is a new Zintl compound (with a composition closer to Yb10.5MgSb9) and a promising thermoelectric material first reported in this work. Undoped Yb10MgSb9 has an ultralow thermal conductivity due to crystallographic complexity and exhibits a relatively high peak p‐type Seebeck coefficient and high electrical resistivity. This is consistent with Zintl counting and density functional theory (DFT) calculations that the composition Yb10.5MgSb9 should be a semiconductor. Na is found experimentally to be an effective p‐type dopant potentially due to the replacement of Na+ for Yb2+, allowing for a significant decrease in electrical resistivity. With doping, a dramatic improvement of electrical conductivity is observed and the glass‐like thermal conductivity remains low, allowing for a significant enhancement of the thermoelectric figure of merit, zT. Doping increases the zT from 0.23 in undoped Yb10MgSb9 to 1.06 in 7 at% Na‐doped Yb10MgSb9 at 873K. This high thermoelectric performance found through Na‐doping places this material amongst the leading p‐type Zintl thermoelectrics, making it a promising candidate for future studies and high‐temperature thermoelectric applications.
15 September 2022 in PRX Energy
The optimization of thermoelectric materials for use in various applications, such as spacecraft power generation, waste heat recovery, and Peltier coolers, requires a careful optimization of material properties. This can be achieved via defect engineering in which defects are purposefully added to a material to produce desired properties. In this tutorial, we discuss a defect engineering strategy called phase-boundary mapping. While many compound thermoelectric semiconductors are often called “line compounds” due to their appearance as a line on a binary phase diagram, in reality, due to the laws of thermodynamics, all phases have a finite phase width. The edges of this phase space define the chemical potential of the material. By making small compositional changes across this phase space, appreciable differences in thermoelectric properties are observed due to this change in the chemical potential. Additionally, the phase equilibria of a thermoelectric material impacts alloying and dopability that further impacts material properties. Phase-boundary mapping is a strategy that allows us to explore the limits of a material and ultimately reproducibly optimize thermoelectric performance by considering the effects of off-stoichiometry on chemical potential, and thus defect energies and material properties. This technique can be applied in the optimization of numerous thermoelectric materials as well as extended to other semiconductors with properties controlled by defects.
1 July 2022 in Journal of Materials Chemistry A
This first report of the thermal conductivity in Yb10MnSb9 shows an ultralow thermal conductivity, even lower than Yb14MnSb11. This along with a high Seebeck value, gives this material a moderate zT which has room for further improvement.
16 December 2021 in Materials Horizons
Fracture mechanics is a fundamental topic to materials science.