29 December 2008 in Applied Physics Letters
The effect of oxygen-vacancy-related defects on gas-sensing properties of ZnO-nanowire gas sensors was investigated. Gas sensors were fabricated by growing ZnO nanowires bridging the gap between two prepatterned Au catalysts. The sensor displayed fast response and recovery behavior with a maximum sensitivity to gas at . Gas sensitivity was found to be linearly proportional to the photoluminescence intensity of oxygen-vacancy-related defects in both as-fabricated and defect-controlled gas sensors by postannealing in Ar and atmosphere. This result agrees well with previous theoretical prediction that oxygen vacancies play a role of preferential adsorption sites for molecules.
5 February 2008 in Nanotechnology
We fabricated a nanowire-based gas sensor using a simple method of growing SnO(2) nanowires bridging the gap between two pre-patterned Au catalysts, in which the electrical contacts to the nanowires are self-assembled during the synthesis of the nanowires. The gas sensing capability of this network-structured gas sensor was demonstrated using a diluted NO(2). The sensitivity, as a function of temperature, was highest at 200 °C and was determined to be 18 and 180 when the NO(2) concentration was 0.5 and 5 ppm, respectively. Our sensor showed higher sensitivity compared to different types of sensors including SnO(2) powder-based thin films, SnO(2) coating on carbon nanotubes or single/multiple SnO(2) nanobelts. The enhanced sensitivity was attributed to the additional modulation of the sensor resistance due to the potential barrier at nanowire/nanowire junctions as well as the surface depletion region of each nanowire.
1 April 2009 in Sensors and Actuators B: Chemical
31 August 2007 in Nano Letters
27 November 2003 in Journal of Materials Chemistry
Ultrawide ZnO nanosheets together with their formation mechanism have been reported. As the width and thickness of the sheets are in the range of 50–100 µm and 50–100 nm respectively, the width-to-thickness ratios of the sheets reach up to one thousand.
13 October 2009 in Nanotechnology
We propose a promising synthetic technique, which we term 'self-supported nanostructuring', for the direct growth of one-dimensional, SnO2 nanowires on the current collector. The technique is based on a vapor-liquid-solid (VLS) mechanism via thermal evaporation at low synthetic temperature (600 degrees C). The as-synthesized SnO2 nanowire electrode did not have any buffer layer prior to the nanowire evolution, and exhibited a single crystalline phase with highly uniform morphology and a thin diameter ranging from 40 to 50 nm with a length of more than 1 microm. The SnO2 nanowire electrode demonstrated stable cycling behaviors and delivered a high specific discharge capacity of 510 mA h g(-1), even at the 50th cycle, which exceeded that of SnO2 nanopowder and Sn nanopowder electrodes. Furthermore, the SnO2 nanowire electrode displayed superior rate capabilities with a rechargeable discharge capacity of 600 mA h g(-1) at 3 C (where 1 C = 782 mA g(-1)), 530 mA h g(-1) at 5 C, and 440 mA h g(-1) at 10 C. Our results support the potential opportunity for developing high-performance Li-ion batteries based on Li-alloying anode materials in terms of high-power density and high-energy density.