In this paper, the effect of HPMC (hydroxypropyl methyl cellulose ether) on the cement mortar water retention (WR) and composition was studied. The relationship between the plastic viscosity and water retention of cement mortar was revealed. The results showed that HPMC formed a colloidal film with a 3D network structure in water, which changed the ability of water to migrate. The HPMC colloid adsorbed on the surface of cement and sand particles and played a bridging role due to the influence of the spatial network structure of the thin film. Fine particles formed a grid-like distribution, and the hydration products formed a unique fibrous tree-like structure. A positive correlation was observed between the plastic viscosity and the water holding capacity of cement mortar. Finally, the mechanism responsible for the improved water retention of cement mortar by HPMC was analyzed using the changing water migration capacity, migration channels, and mortar cohesion.
5 October 2011 in Journal of Thermal Analysis and Calorimetry
AFt is one of the major products at the early stage of cement hydration. It is an important product that influences the performance of the fresh and hardened cement pastes such as the setting time. However, there is a lack of detailed investigation on the growth of AFt in the cement pastes with a long-time scale. In this work, we reported a detailed analysis by using in-situ powder X-ray diffraction (XRD) on the growth of AFt in the cement pastes during hydration. Samples of the hydrated ordinary Portland cement (OPC) and another locally produced Portland cement with very high tricalcium silicate (C3S) content with different water–cement (w/c) ratios were investigated continually till they were hydrated for about 270 days by powder XRD. The work shows that during Portland cement hydration, the AFt reaches its maximum content with very high speed within about 24 h, which is influenced by the content of C3S in the raw cement samples and the w/c ratios of the cement pastes. Once the maximum content of AFt was reached, it decreases very fast within the following couple of days, and then decreases slowly and finally reaches a stable level at the late stage of hydration. The results also present that a lower w/c ratio is beneficial to the formation of AFt and the conversion of AFt to AFm as well. While higher w/c ratios are favorable for the AFt to remain stable in the hardened cement pastes.
5 August 2014 in Journal of Wuhan University of Technology-Mater. Sci. Ed.
This paper describes the results of an investigation into the effect of the variation of curing temperatures between 0 and 60 °C on the hydration process, pore structure variation, and compressive strength development of activated coal gangue-cement blend (ACGC). Hardened ACGC pastes cured for hydration periods from 1 to 360 d were examined using the non-evaporable water method, thermal analysis, mercury intrusion porosimetry, and mechanical testing. To evaluate the specific effect of activated coal gangue (ACG) as a supplementary cementing material (SCM), a fly ash-cement blend (FAC) was used as a control. Results show that raising the curing temperature accelerates pozzolanic reactions involving the SCMs, increasing the degree of hydration of the cement blends, and hence increasing the rate of improvement in strength. The effect of curing temperature on FAC is greater than that on ACGC. The pore structure of the hardened cement paste is improved by increasing the curing temperature up to 40 °C, but when the curing temperature reaches 60 °C, the changing nature of the pore structure leads to a decrease in strength. The correlation between compressive strength and the degree of hydration and porosity is linear in nature.