Bruno Ghyselen

Bruno Ghyselen

Auto-generated profile, based on publicly available information

Bruno Ghyselen

SOITEC Parc Technologique des Fontaines 38190 Bernin France

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 December 2021 in Physica Status Solidi (a)
Verified
Journal Article
Closed access
PDF file
BGBruno Ghyselen
Bruno Ghyselen
CNChristelle Navone
Christelle Navone
MMMuriel Martinez
Muriel Martinez
LSLoic Sanchez
Loic Sanchez
CLChristophe Lecouvey
Christophe Lecouvey
IRIonut Radu
Ionut Radu

1 April 2006 in Solid-State Electronics
Verified
Journal Article
Closed access
FAF. Andrieu
F. Andrieu
TET. Ernst
T. Ernst
OFO. Faynot
O. Faynot
ORO. Rozeau
O. Rozeau
YBY. Bogumilowicz
Y. Bogumilowicz
SDS. Deleonibus
S. Deleonibus

8 September 2025 in Journal of Applied Physics
Verified
Journal Article
Open access
CBClaire Besancon
Claire Besancon
FMF. Martin
F. Martin
BGB. Ghyselen
B. Ghyselen
LLL. Largeau
L. Largeau
Frank FournelFrank Fournel
Frank Fournel
JDJ. Decobert
J. Decobert
Hetero-integration of InP-based compound semiconductors on CMOS-compatible silicon is desirable for low-cost large-scale applications. Recently, an approach consisting of integrating a thin InP buffer layer onto a silicon (InPoSi) substrate through direct bonding, followed by epitaxial regrowth on the bonded layer has been developed. It allows us to avoid the two major defects origins, antiphase domains and lattice mismatch, of the direct III–V/Si epitaxial approach. The remaining challenge comes from the difference of coefficients of thermal expansion between InP and Si, leading to a compressively strained InP seed layer at growth temperature. The latter was assessed from the curvature signal registered by in situ metrology during etching on the InP layer at typical growth temperature (640 °C) using a PH3/CBr4 mixture. The thermal strain effects on different heterostructures grown by MOVPE on InPoSi were studied by microscopy, Atomic Force Microscopy (AFM), x-ray diffraction (XRD), and photoluminescence measurements. In particular, regularly undulating surface topology was observed by microscopy, which could be associated with a broadening of the XRD peaks for heterostructures thicker than 1.5 μm. Strain-free InP-based structures were grown on InPoSi by adding 1% of Ga to the InP bulk layers to form an In0.99Ga0.01P alloy lattice-matched at growth temperature to the compressively strained InP bonded seed. The undulation for this strain-engineered film was hardly noticeable by AFM and was, therefore, successfully limited.

21 February 2022 in Physica Status Solidi (a)
Verified
Journal Article
Closed access
BGBruno Ghyselen
Bruno Ghyselen
CNChristelle Navone
Christelle Navone
MMMuriel Martinez
Muriel Martinez
LSLoic Sanchez
Loic Sanchez
CLChristophe Lecouvey
Christophe Lecouvey
IRIonut Radu
Ionut Radu