12 November 2020 in IEEE Access
This paper proposes a method for visibility detection based on the recognition of the preceding vehicle’s taillight signals using in-vehicle camera and millimeter-wave (mm-W) radar. First, we design two methods of vehicle identification. One is to use Haar-like features and an AdaBoost algorithm to train the vehicle classifier, which is mainly used to identify vehicles without turning on the taillights. The other is to identify vehicles with taillights on by means of taillight segmentation. The two identification methods are combined with a Discriminative Scale Space Tracker (DSST) to track the vehicle in the image acquired by vehicle camera and to measure anthropic visibility with mm-W radar. In addition, we drove a test vehicle on a foggy highway and collected experimental data through in-vehicle camera and mm-W radar. The experimenter observed the movement of the vehicle in front until it disappeared from the field of vision and recorded the distance of the vehicle in front measured by radar at that time as human visibility, which was also used as the ground truth to verify the accuracy of the proposed visibility detection method. The experimental results show that the visibility measured by the proposed algorithm is essentially consistent with the visibility obtained by human eyes, that is, the visibility of vehicles with no taillights, clearance lamp, emergency flasher, or fog lamp tends to rise, with an average accuracy of 88%, 91%, 90%, and 95%, respectively. In contrast to the traditional visibility measurement, this method mainly measures the maximum distance that the driver can observe when the front vehicle is not turned on or different taillights are turned on.
22 November 2024 in IEEE Internet of Things Journal
Connected and Autonomous Vehicles (CAVs) are emerging as a potential solution to merging safety problems. However, in mixed traffic scenarios where CAVs coexist with Human-driven Vehicles (HVs), challenges arise due to the lack of proactive cooperation and the limited length of the acceleration lane, complicating the merging processes of CAVs. In these cases, CAVs should actively seize the transit opportunity and perform safe and efficient merging. Failure to do so can lead to decreased traffic efficiency, increased fuel consumption and emissions, compromised self-merging capacities, and heightened crash risk. Therefore, this paper employs the roadside unit and proposes a two-level hierarchical self-merging strategy for CAVs to increase the merging efficiency while ensuring high safety. Since the Surrogate Safety Measures (SSM) can formulate reliable safety assessment and identify the merging conflict risk by setting appropriate threshold, the upper level uses a novel SSM-based method (i.e., the MInimum Acceleration Rate, MIAR) to determine the Merging Sequence (MS). A Theoretical Model for Merging Safety (TMMS) is developed to estimate the MIAR value, and the MIAR threshold is determined using Signal Detection Theory (SDT). At the lower level, the strategy recommends the optimized merging maneuvers, pre-generated using Sequential Quadratic Programming-Model Predictive Control (SQP-MPC), based on the determined MS and the CAV’s velocity. A case study at a real-world freeway merging area demonstrates the effectiveness of the MIAR in measuring merging conflict risk. Besides, numerous simulations are conducted, and the results demonstrate that the proposed strategy significantly improves merging success rate and overall traffic efficiency.