China’s Mars rover Zhurong successfully landed on Mars on 15 May 2021, and it is currently conducting an exploration mission on the Red Planet. This paper develops slip estimation models for the Mars rover Zhurong based on the data drive approach. Data were obtained by Zhurong’s validator ground indoor tests, and the test site was equipped with a low-gravity simulation device and simulated Mars soil to simulate the Mars conditions as much as possible. The obtained slip models trained by BP and GA-BP algorithms were applied to estimate Zhurong’s longitudinal (slip_x) and lateral slip (slip_y) on Mars, and the slip estimation values were used to display Zhurong’s actual driving path. The analyzed results prove that the GA-BP slip models perform better than the BP models, and can both be applied for correcting Zhurong’s path. The proposed models have high potential in guiding the path planning and monitoring of the slip for the Mars rover Zhurong.
Monitoring the rover slip is important; however, a certain level of estimation uncertainty is inevitable. In this paper, we establish slip estimation models for China’s Mars rover, Zhurong, using Gaussian process regression (GPR). The model was able to predict not only the average value of the longitudinal (slip_x) and lateral slip (slip_y), but also the maximum possible value that slip_x and slip_y could reach. The training data were collected on two simulated soils, TYII-2 and JLU Mars-2, and the GA-BP algorithm was applied as a comparison. The analysis results demonstrated that the soil type and dataset source had a direct impact on the applicability of the slip model on Mars conditions. The properties of the Martian soil near the Zhurong landing site were closer to the JLU Mars-2 simulated soil. The proposed GPR model had high estimation accuracy and estimation potential in slip value, and a 95% confidence interval that the rover could reach during motion. This work was part of a research effort aimed at ensuring the safety of Zhurong. The slip value may be used in subsequent path tracking research, and the slip confidence interval will be able to help guide path planning.
24 April 2021 in Mathematical Problems in Engineering
The static contact characteristics of heavy-duty tracked vehicle roller and track plate contact structure are analyzed, and the influence mechanism of the roller’s shape parameters on the contact stress is studied. According to the Hertz contact theory, a mathematical model of the roller and track plate contact is established. The contact structure model is established in ANSYS software, and the simulation results are compared with the Hertz theory results to verify each other. In the parameter optimization section for the roller and track plate, based on the Hertz stress calculation formula, a new method is proposed to establish a roller and track plate Kriging model and to globally optimize the model by the genetic algorithm (GA). After that, the relationship among the track roller radius , the track roller rim radius , and the track plate rim radius is analyzed. The results show that the difference between the radius of the rim of the roller and the track plate and the radius of the roller rim both affect the maximum contact stress. Changing the plane contact into the curved surface contact can reduce the maximum contact stress by 33%. This study can provide a reference for the design and manufacture of supporting track rollers and track plates.
Dynamic unbalance force is an important factor affecting the service life of scrap metal shredders (SMSs) as the product of mass error. Due to the complexity of hammerheads arrangement, it is difficult to take all the parts of the hammerhead into account in the traditional methods. A novel optimization algorithm combining genetic algorithm and simulated annealing algorithm is proposed to improve the dynamic balance of scrap metal shredders. The optimization of hammerheads and fenders on SMS in this paper is considered as a multiple traveling salesman problem (MTSP), which is a kind of NP‐hard problem. To solve this problem, an improved genetic algorithm (IGA) combined with the global optimization characteristics of genetic algorithm (GA) and the local optimal solution of simulated annealing algorithm (SA) is proposed in this paper, which adopts SA in the process of selecting subpopulations. The optimization results show that the resultant force of the shredder central shaft by using IGA is less than the traditional metaheuristic algorithm, which greatly improves the dynamic balance of the SMS. Validated via ADAMS simulation, the results are in good agreement with the theoretical optimization analysis.