Experiments were conducted to investigate light absorption of organic aerosol (OA) in fresh and photo-chemically aged biomass-burning emissions. The experiments considered residential hardwood fuel (oak) and fuels commonly consumed in wild-land and prescribed fires in the United States (pocosin pine and gallberry). Photo-chemical aging was performed in an environmental chamber. We constrained the effective light-absorption properties of the OA using conservative limiting assumptions, and found that both primary organic aerosol (POA) in the fresh emissions and secondary organic aerosol (SOA) produced by photo-chemical aging contain brown carbon, and absorb light to a significant extent. This work presents the first direct evidence that SOA produced in aged biomass-burning emissions is absorptive. For the investigated fuels, SOA is less absorptive than POA in the long visible, but exhibits stronger wavelength-dependence and is more absorptive in the short visible and near-UV. Light absorption by SOA in biomass-burning emissions might be an important contributor to the global radiative forcing budget.
We present global direct radiative effect (DRE) calculations of carbonaceous aerosols emitted from biomass/biofuel burning addressing the interplay between two poorly constrained contributions to DRE: mixing state of black carbon (lensing) and light absorption by organic aerosol (OA) due to the presence of brown carbon (BrC). We use the parameterization of Saleh et al. (2014) which captures the variability in biomass/biofuel OA absorption. The global mean effect of OA absorption is +0.22 W/m2 and +0.12 W/m2 for externally and internally mixed cases, while the effect of lensing is +0.39 W/m2 and +0.29 W/m2 for nonabsorbing and absorbing OA cases, signifying the nonlinear interplay between OA absorption and lensing. These two effects can be overestimated if not treated simultaneously in radiative transfer calculations. The combined effect of OA absorption and lensing increases the global mean DRE of biomass/biofuel aerosols from −0.46 W/m2 to +0.05 W/m2 and appears to reduce the gap between existing model‐based and observationally constrained DRE estimates. We observed a strong sensitivity to these parameters in key regions, where DRE shifts from strongly negative (< −1 W/m2) to strongly positive (> +1 W/m2) when accounting for lensing and OA absorption.