1 January 2012 in Acta Biomaterialia
1 July 2011 in Surface and Coatings Technology
PRPhilipp Rudolf von Rohr
7 February 2012 in Plasma Processes and Polymers
1 August 1995 in Steel Research
19 February 2013 in Textile Research Journal
The moisture transport in fabrics determines its cooling effect and therefore the wearing comfort during sudorific activities. When liquid sweat is present, the moisture absorption by a fabric is characterized by the in-plane and transplanar wicking. We investigated the effect of fabric structure and fiber count on wicking by X-ray projection images using four different polyester knit structures (rib, eyelet, interlock and modified interlock, all hydrophilic), as well as five rib knits with different fiber counts per yarn (24–192, all quasi-hydrophobic with water contact angles 89 ± 1). Experiments were conducted with two-layer samples of the same fabric exposed to different external pressures. The liquid was transported in recognizable waterfronts, which can be interpreted as distinct intra-yarn and inter-yarn in-plane wicking fronts. For layer-to-layer wicking in hydrophilic samples, pressure-dependent time delays were observed; the delays correlated negatively with the relative void area at the interface, and were shortest for the rib knits. For the quasi-hydrophobic samples, however, the liquid wicked up to the upper layer without time delays, which was due to the liquid being pressed into the fabric, that is, due to the supply-driven flow. We distinguish this from the supply-limited flow, which is driven by capillary forces. The presented results have implications for the design of clothing systems for sudorific activities.
6 May 2009 in Plasma Processes and Polymers
The surface of fine lactose powder particulates was modified by direct‐plasma exposure in a radio frequency (RF) discharge, in a mixture of oxygen and hexamethyldisiloxane (HMDSO) diluted in argon. Besides, the RF power (100–500 W) and the HMDSO flow rate (0–68 sccm) at constant oxygen‐to‐HMDSO flow rate ratio of 10 was varied in this study. Apart from the relatively high pressure of 2 mbar, the plasma process adopted is very much alike the plasma enhanced chemical vapor deposition of silica‐like material descending from the plasma‐chemical reaction of oxygen and HMDSO. With respect to the processability of powders in production lines to be solely gravity‐driven, as for instance in the event of dye‐filling, compression ratios (based on the powder bulk and mass density) were measured for solely gravity‐driven filling of a graduated glass. A jolting volumeter was used to provide the compressibility of the compacted powder bulk. Higher compressibility of about 20% (improvement rate) was found for both experimental series: variation of HMDSO flow rate and variation of the discharge power. In both cases, an enhancement of the flowability of the powder was found to cause the compressibility improvement.