Wanrong Lin

Wanrong Lin

Auto-generated profile, based on publicly available information

Wanrong Lin

Chongqing University, Chongqing, Chongqing, 400044, CHINA

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 January 2023 in Energy Conversion and Management
Verified
Journal Article
Closed access
ZXZhengqiu Xie
Zhengqiu Xie
LLLiang Liu
Liang Liu
WHWenbin Huang
Wenbin Huang
RSRuizhi Shu
Ruizhi Shu
SGShuaishuai Ge
Shuaishuai Ge
WLWanrong Lin
Wanrong Lin

20 February 2023 in IEEE Transactions on Industrial Informatics
Verified
Journal Article
Closed access
YXYunfei Xu
Yunfei Xu
Quanchang LiQuanchang Li
Quanchang Li
WLWanrong Lin
Wanrong Lin
QWQihang Wu
Qihang Wu
WHWenbin Huang
Wenbin Huang
XDXiaoxi Ding
Xiaoxi Ding
Sensor nodes have been widely used for mechanical equipment condition monitoring, especially for enclosed metal structures. In these cases, it is important to achieve communication between the sensor nodes inside the enclosed metal structures and the outside receiver node. Conventional wired communication using cables will affect the structural integrity, and wireless communication using electromagnetic waves will be shielded by metal structures, so neither is desirable. Motivated by these issues, this article proposes a Lamb-waves-based sparse distributed penetrating communication (SDPC) system using the propagation characteristics of Lamb waves considered harmful in previous studies to accomplish wireless simultaneous data communication. Combining phase-shift keying and pulse position modulation mechanisms, a phase-position modulation (P-PM) technology is proposed to improve the communication rate. To overcome the intersymbol interference problem caused by the propagation characteristics of Lamb waves, a phase-position sparse reconstruction strategy is proposed for demodulation, which is more convenient and accurate compared with the conventional cross-correlation method. It should be noted that the maximum bit rate without bit error reaches 830.48 kbps via P-PM parameter optimization, which is 8.3 times higher than that of on – off keying modulation approach under the same experimental conditions. Finally, distributed communication experiments and simulations further verify the high accuracy, efficiency, and strong robustness of the proposed SDPC system, which can meet the communication requirements of enclosed metal structures.

10 October 2022 in Smart Materials and Structures
Verified
Journal Article
Closed access
WLWanrong Lin
Wanrong Lin
YXYunfei Xu
Yunfei Xu
SWSijia Wang
Sijia Wang
ZCZhiwen Chen
Zhiwen Chen
ZXZhengqiu Xie
Zhengqiu Xie
WHWenbin Huang
Wenbin Huang
Magnetically coupled dual-beam energy harvesters have been presented by several researches to achieve a broader response bandwidth. However, in the low frequency operating environment with limited space, the dimension of the piezoelectric beam is limited which leads to high stiffness of the generated beam. Therefore, the output of dual-beam system is relatively low under low frequency and amplitude vibrations. In this paper, a nonlinear magnetic and torsional spring coupling energy harvester is proposed. The stiffness of the torsional spring can be easily adjusted to make the designed harvester suitable for low frequency vibrations. The introduction of torsion springs provides an extra degree of freedom to the system and broadens the response band of the system from 8.7 Hz to 15 Hz. Furthermore, the presence of the 1:3 internal resonance phenomenon in the harvester considerably achieves frequency enhancement and bandwidth extension, significantly improving the harvesting performance in low frequency environments. Numerical analysis, simulation, and experimental are carried out to verify that the proposed energy harvester is capable of harvesting low frequency wideband vibration energy. The results show that magnetic and torsional spring coupling piezoelectric energy harvester is capable of broadband energy harvesting in the range of 5–20 Hz (i.e. 15 Hz bandwidth).

13 December 2022 in Smart Materials and Structures
Verified
Journal Article
Closed access
WHWenbin Huang
Wenbin Huang
ZCZhiwen Chen
Zhiwen Chen
WLWanrong Lin
Wanrong Lin
SWSijia Wang
Sijia Wang
ZXZhengqiu Xie
Zhengqiu Xie
Up to now, many nonlinear techniques such as bistable structure have been used to harvest vibration energy from the environment to achieve a wide response bandwidth. However, most bistable harvesters require two opposing magnets to form the potential energy function, which limits the miniaturization of the harvesters. In this paper, a two-degree-of-freedom U-shaped single magnet bistable energy harvester (SMBEH) based on the internal resonance technique is proposed. The harvester consists of a U-shaped beam, a magnet and a tip mass. The governing equations of the system are derived and the output performance of the harvester is obtained through numerical simulation and experiments which are in good agreement. The proposed SMBEH can achieve low frequency energy harvesting by utilizing a 1:2 internal resonance. When the excitation amplitude is equal to 0.4 g, the SMBEH can produce a significant output in two frequency ranges from 7 Hz to 7.7 Hz and 11.7 Hz to 15.73 Hz, which broaden the output frequency band. In the end, the output performance of SMBEH at different resistances and the charging performance were verified, respectively.

13 December 2023 in Smart Materials and Structures
Verified
Journal Article
Open access
PDF file
PZPan Zhang
Pan Zhang
WLWanrong Lin
Wanrong Lin
WHWenbin Huang
Wenbin Huang
KWKuankuan Wang
Kuankuan Wang
The security of transmission line towers is crucial to industrial development. Bird damage is a significant threat to transmission line towers in the field. However, the power supply to the bird-repellent devices is limited. In this work, we propose a rotation differential triboelectric nanogenerator (RD-TENG) to harvest wind energy for supplying electrical power to bird-repellent on transmission line towers. On the transmission line towers, the RD-TENG converts wind energy into electrical energy by rotation differential structure and stores power in a 1000 μF capacitor, then supplies power to the buzzer for bird-repellent. The device mainly consists of a wind cup, an input gear, output gears, and rotors. The RD-TENG can achieve double rotation speed by rotating the differential structure compared to the single gear counterpart, hence doubling the current and power output through triboelectric nanogenerator. The RD-TENG has a starting wind speed of 4 m s−1 and can operate normally at lower wind speeds. At a wind speed of 8 m s−1, the output performance of the RD-TENG is 830 V, 13.5 μA, 330 nC, and the peak power is 19.6 mW. This work realizes a new solution for bird-repellent on transmission lines through the TENG energy harvesting technique and also contributes to the subsequent smart grid construction.

2 December 2023 in Sustainable Energy Technologies and Assessments
Verified
Journal Article
Closed access
WLWanrong Lin
Wanrong Lin
PZPan Zhang
Pan Zhang
ZXZhengqiu Xie
Zhengqiu Xie
WHWenbin Huang
Wenbin Huang