8 February 2017 in AIP Advances
Spin-torque nano-oscillators (STO) are candidates for the next technological implementation of spintronic devices in commercial electronic systems. For use in microwave applications, improving the noise figures by efficient control of their phase dynamics is a mandatory requirement. In order to achieve this, we developed a compact phase locked loop (PLL) based on custom integrated circuits (ICs) and demonstrate that it represents an efficient way to reduce the phase noise level of a vortex based STO. The advantage of our approach to phase stabilize STOs is that our compact system is highly reconfigurable e.g. in terms of the frequency divider ratio N, RF gain and loop gain. This makes it robust against device to device variations and at the same time compatible with a large range of STOs. Moreover, by taking advantage of the natural highly non-isochronous nature of the STO, the STO frequency can be easily controlled by e.g. changing the divider ratio N.
2 November 2020 in IEEE Transactions on Instrumentation and Measurement
This work presents a real-time 100Base-TX Ethernet physical layer (PHY) transceiver chip implemented in a 180nm technology. The PHY chip implements a highly accurate hardware timestamping by using an 8 Bit digital-to-phase converter (DPC) generating 256 phases of the 125MHz system clock. Using these clock phases, spaced 31.25 ps apart from each other, phase relationships can be evaluated to timestamp ingress and egress frames with improved resolution. Connected by up to 120m long category 5 unshielded twisted pair cables, two of these PHY chips are used to demonstrate the synchronization in a two-node scenario. A proportional-integral (PI)-clock-servo is used at the slave for the synchronization. To optimize the performance, the parameters of the controller need to be chosen carefully. To do so, a simple model is used to find a suitable bandwidth of the controller as a trade-off between the noise of the timestamping and the noise of the oscillator. All in all, a synchronization accuracy with a standard deviation of only 64 ps and a mean offset well below 100 ps is achieved in the given scenario. To the best of the authors knowledge, this is the highest synchronization accuracy over copper-based Ethernet, reported to date.
25 August 2020 in IEEE Transactions on Instrumentation and Measurement
A current sense amplifier based on a fully-differential difference amplifier (FDDA) is introduced. A prototype was manufactured in a 0.18 μm BCD (Bipolar, CMOS, DMOS) technology of TSMC and characterized. The FDDA architecture offers several benefits regarding gain, bandwidth, and noise performance and is well suited for low-side phase-current measurement (PCM) in modern electric engines. In order to achieve a high gain accuracy, an integrated resistive feedback, which offers a low-frequency gain of more than 46 dB with a gain error of less than 1% and a 3 dB-bandwidth of approximately 2 MHz simulated and confirmed by measurements, is used. Hence, the circuit offers a higher measurement speed and sensitivity than current state-ofthe-art devices. Furthermore, the manual offset reduction allows for an input offset in the low μV range, and the input referred noise is reduced to an input noise voltage of less than 30 μV (rms) and a noise floor of 13 nV/√Hz (above 30 kHz). This paper describes the design including the top-level structure, the distinct gain stages as well as the common-mode feedback (CMFB) and the output buffer amplifier of the current sense amplifier in detail. Finally, a measurement with a noisy rectangular 1 mV, 500 kHz signal proves the great potential of the amplifier for low-side PCM which is further compared with state-of-the-art commercial products and research results.
1 February 2022 in IEEE Transactions on Microwave Theory and Techniques
This research work presents the analysis, design, and characterization of a concept for an mm-wave divide-by-4 frequency divider utilizing an extended true single-phase clock (E-TSPC) and a TSPC divide-by-2 stage. The divider operates from 16 to 70 GHz from a 0.8-V supply with the highest power consumption of 0.35 mW. Operating frequencies up to 53 GHz were reached with a supply voltage of only 0.5 V at 0.12-mW power consumption. The self-resonance frequency of the circuit is adjustable through backgate biasing from 40 up to 70 GHz at 0.9-V supply, allowing a reduction in the required input power in this frequency range. Locking ranges up to 114% have been measured by changing only the backgate voltage. The circuit design is illustrated in detail and supported with original analysis and an explicit expression to calculate the self-oscillation frequency of the E-TSPC divider. The presented circuit was fabricated on a 22-nm fully depleted silicon-on-isolator complementary metal–oxide–semiconductor (CMOS) technology and occupies an active area of $3.4 ~\mu \text{m}^{2}$ . The circuit requires the lowest power consumption and area among state-of-the-art RF frequency dividers, while it demonstrates the second widest adjustable operating frequency range and the second highest self-resonance frequency for CMOS D-flip-flop frequency dividers.