29 June 2013 in Journal of Applied Polymer Science
5 July 2012 in ACS Applied Materials & Interfaces
11 July 2017 in Journal of Industrial Textiles
Chitosan-blended cellulose monoacetate nanofibers were prepared through electrospinning process. Neat nanofibers and their sodium hydroxide-treated analogs were used as support surfaces for protease immobilization via physical adsorption method. Morphologies of the nanofibers were observed with a scanning electron microscopy. Chemical analyses were conducted with Fourier transform infrared spectroscopy, and thermal analyses were carried out with differential scanning calorimeter and thermogravimetric analyzer. Immobilized enzyme activities were measured by using casein substrate. In order to test the stability of immobilized enzymes, the tests were repeated until the immobilized enzyme activity was leveled off. The results reveal that well uniform cellulose monoacetate/chitosan nanofibers were obtained, and nanofiber structures are transformed from rounded to more flattened morphology after enzyme activation test. Glutaraldehyde activation has positive effect on sodium hydroxide-treated samples, and the highest immobilization yield as about 83% was observed for glutaraldehyde-treated cellulose monoacetate/chitosan samples. Sodium hydroxide treatment before glutaraldehyde activation shows the best results for protease immobilization on cellulose monoacetate and cellulose monoacetate/chitosan nanofibers. Operational stability increases after sodium hydroxide treatment and glutaraldehyde activation. Glutaraldehyde activation effectively increased the cycle number after sodium hydroxide treatment and about 20% of enzyme activity was still retained after seven cycles at cellulose monoacetate/chitosan samples. This percentage is higher at pure cellulose monoacetate nanofibers than cellulose monoacetate/chitosan nanofibers and measured around 33.5%.
1 July 2018 in Journal of Physics and Chemistry of Solids
22 July 2020 in Journal of Industrial Textiles
One-step and rapid preparation of natural fiber woven fabric reinforced hydrogel composites via simultaneous dissolution and crosslinking of polyvinyl alcohol (PVA) yarns in the fabric was reported. In this regards, PVA/Cotton (C), PVA/Flax (F) and PVA/Wool (W) blended woven fabrics were prepared for the manufacturing fabric reinforced hydrogel composites. The hybrid woven fabric reinforced fabrics were treated with different concentrations of borax solutions. Aqueous borax solutions were used to alter the PVA yarns in the fabric into cross-linked structure in order to enhance mechanical performance of the hydrogel composite. Morphological investigation of hydrogel composites in a dried form was carried out by scanning electron microscopy (SEM) imaging. The chemical characterization of aqueous borax treated samples was examined by fourier-transform infrared spectroscopy (FTIR) measurements. Mechanical performances of the hydrogel composites were observed by tensile measurements. Thermogravimetric analysis (TGA) was conducted to characterize thermal stability of hydrogel composites. The results revealed that natural fiber woven fabric reinforcement significantly enhanced the mechanical strength of hydrogel composites, and wool fabric reinforced composite had better mechanical performance than its cotton and flax counterparts. Due to the low mechanical properties of hydrogels in general, the prepared fabric reinforced hydrogel composites could be used in hydrogel applications where mechanical strength is critically important.
15 September 2017 in Journal of Applied Polymer Science