Scientific and Educational Center “Perspective Materials and Technologies in Subsoil Use,” National Research Tomsk State University, 36, Lenin Ave., 634050 Tomsk, Russia
Auto-generated profile, based on publicly available information
Vyacheslav A. Yanovsky
Scientific and Educational Center “Perspective Materials and Technologies in Subsoil Use,” National Research Tomsk State University, 36, Lenin Ave., 634050 Tomsk, Russia
This paper presents an experimental and theoretical study of Newtonian and non-Newtonian (Bingham plastic) emulsion drop impact on a solid non-heated surface. The utilization of different emulsifiers at a constant concentration of continuous and dispersed phases in emulsions allows the considerable variation of the surface tension at the liquid–liquid interface. Our data for the maximum spreading diameter of water, n-decane, and emulsion drops impacting on a surface are compared with that predicted from the existing models for single-phase liquid drops. All selected models underpredict the experimental data. As a result, the importance of considering the capillary effects at the internal interfaces of the emulsion drops and the careful examination of all rheological properties in the case of Bingham plastic fluids is confirmed experimentally and is taken into account theoretically. The models of Pasandideh-Fard et al. [“Capillary effects during droplet impact on a solid surface,” Phys. Fluids 8, 650 (1996)] and Ukiwe and Kwok [“On the maximum spreading diameter of impacting droplets on well-prepared solid surfaces,” Langmuir 21, 666–673 (2005)] are modified and adapted to the emulsion drop by means of including the additional surface energy term at the liquid–liquid interface of the emulsion drop in the energy conservation equation and the non-Newtonian Reynolds number. The predictions of the maximum spreading diameter give good agreement with the measured one. Several constraints and future lines of research that relate to a specific behavior of the compound liquid drops at the impact on a solid surface are highlighted.
Using the promising fuel microemulsions based on diesel fuel (29.41–95.33 vol. %) and the mixture of diesel fuel with the vegetable additive in the form of methyl esters of rapeseed oil (4.80–43.27 vol. %) stabilized by the nonionic surfactant, polyethylene glycol ester of isononylphenol, and the co-surfactant, 2-ethylhexanol (total emulsifier concentration of 2.72–41.18 vol.%), we investigated their thermal stability (up to 100–110 °C). Two methods to determine the thermal stability of the microemulsions are proposed, namely, the express thermostatting method and the long-term one. Based on the results obtained, the analysis of the influence of the microemulsion component composition on the range of their thermal stability is carried out. The introduction of the bioadditive is shown to result in a narrowing of the ranges of existence of the single-phase microemulsion by 10–15 °C. The temperature effect on the dynamic viscosity of the microemulsion systems in their single-phase region is investigated. Based on the fish-cut diagrams for the microemulsions in the coordinates “emulsifier content – temperature,” the color map diagrams are plotted, which show the dependence of the dynamic viscosity of the microemulsions on the specified parameters, namely, temperature, water fraction, and vegetable additive. The assumed regions of existence of microemulsions with a dispersed phase in the form of spherical aggregates are determined in the fish-cut diagrams. Graphical Abstract