25 August 2022 in Smart Materials and Structures
Rolling motions have been observed in many animals and insects. In the previous fluidic rolling system, a deformed chamber and long cables were imperative to drive the soft rolling actuators, which required high pressure and a sophisticated controlling strategy. In this study, we propose a soft fluidic roller using a simple structure composed of a bendable and twistable electrohydrodynamic (EHD) pump and a layer of natural latex. To realize the rolling motion, we first optimized the electrode and channel height of the EHD pumps using different patterns and designs. We also examined the output power, efficiency, pressure loss, bending, and twisting performance. Subsequently, the optimized electrodes and channel height were selected to design the power source of the EHD roller. This roller was lightweight (0.7 g) with an amount of liquid (0.6 g). This EHD robot can roll as the EHD liquid oscillates under a duty-controlled voltage realized using a high-voltage circuit. Next,we investigated the influence of frictional forces on rolling performance. Finally, the rolling motion in the liquid was demonstrated. This study extends the EHD pumps to independent soft actuators integrated with a soft power source.
30 April 2021 in Smart Materials and Structures
An untethered system can realize wide-area activities of soft robots. Herein we develop an untethered DEA wheel (UD-wheel) with a dielectric elastomer actuator (DEA). DEA is a soft actuator driven by electrostatic force. This UD-wheel is a new rotating device that integrates an untethered system and stacked DEAs. The untethered system consists of a small battery and a small high-voltage circuit. All the components are assembled seamlessly. Because the circuit can control four DEAs, the active time that the circuit continues to control the DEAs with a small battery is estimated. The estimated time matches the experimental result. We evaluated the output torque and back-drivability achieved by stacked DEAs installed in a UD-wheel. We also built a theoretical model for an in-depth evaluation. The stacking DEAs method provides a better back-drivability than the reducer method. This study suggests that our untethered rotational system may provide novel functions in soft robotics.
8 November 2023 in IEEE Access
Stretchable sensors can measure large strains generated in the joints of the human body. Generally, in the characteristics of carbon nanotubes (CNTs) based stretchable resistive sensors, the reference resistance (resistance at 0% strain) increases with repeated strain, and the gauge factor (GF) which indicates sensitivity is not constant. These characteristics are related to the rupture of the CNT networks. This study proposes a pre-strain method to produce the resistive strain sensor with linear sensitivity. We discovered that this method aligns the agglomerated CNTs depending on the pre-strain. The pre-strain method is simple because it requires just a brush and stretching jig without the splay, bar-coater or 3D printer. The sensor is completed by applying CNT powder to an elastomer that has been pre-strained 47% in the uniaxial direction and then returning it to its initial state (0% strain). In the strain from 0% to 100%, the GF of the sensor is 1.46 constantly, and the variance of the normalized change in resistance of the sensor is less than 0.06. Therefore, the sensibility of the sensor has strong linearity. This result solves the problem of non-linear sensitivity of sensors using CNT powder in previous research. As a demonstration, we mounted this sensor onto a wearable device for the knee joint. We acquired static angle data and dynamic walking and running data. In static experiments, the relationship between knee joint angle and normalized change in resistance was linear. The maximum uniaxial deformation velocity of 122.1 mm/s could be measured in the dynamic experiment. When the angle was returned to 0° after repeated knee joint bending, the normalized change in resistance returned to the reference value, suggesting that the rupture of the CNT networks was suppressed. These features of constant gauge factor and reference resistance are expected to simplify the system’s data processing.