1 January 2022 in East European Journal of Physics
To increase the speed of information flow and storage capacity in electronic devices laser can be used to carry information instead of electric current. Since the photon is faster than electrons, one expects information to be transmitted very fast through the internet when photons replace electrons. This requires searching for chips that act as capacitors, inductors or resistors. To do this Maxwell's equation for the electric field intensity beside the electron equation of motion were used. The electron is assumed to vibrate naturally inside a frictional medium in the presence of a local electric and magnetic fields. These equations have been used to find a useful expression for the absorption coefficient. The absorption coefficient was found to be dependent on the laser and natural frequencies beside the coefficient of friction in addition to the internal electric and magnetic fields. These parameters can be fine-tuned to make the chip act as a capacitor, inductor or resistor. The laser intensity decreases when the absorption coefficient inecreases. Thus, the absorption coefficient acts as an electic resistor. Therefore, if the absorption coefficient inecreases upon decreasing the frequency the chip acts as a capacitor. But when the absorption coefficient inecreases when the laser frequency inreases the chip acts as an inductor. In the case that the absorption coefficient inecreases with the concentration of the carriers it acts in this situation as a resistor. For magnetic materials with magnetic flux density that cancels the frictional force, when the laser frequency is equal nearly to the atom's natural frequency the material acts as an inductor. But when the frictional force is low with the internal and external electric fields in phase, the material acts as a capacitor. However, it acts as a resistor for negligible natural frequency, when no electric dipoles exist and when the internal magnetic field force balance the frictional force.
2 June 2026 in World Journal of Applied Physics
Superconducting materials pays attention of scientists for its important roles in generation of powerful magnetic field and electric energy beside transportation and magnetic resonance imaging (MRI). In this search, Six cases of the behavior of superconducting materials and Yttrium Barium Copper Oxide (YBCO) compounds were studied. The aim of this work is to explain behavior of superconductors by using quantum, statistical and mechanical laws. The methodology is based on using mathematical derivation based on basic physical laws then comparing the results obtained with experimental foundation. The first case was investigated infinite conductivity, we are assuming that electrical damping serves as a measure of the resistance to the motion of magnetic vortices, which arise due to strong magnetic fields in type-II superconductors. The second and third cases, was compared critical temperature of high-temperature superconductivity on the YBCO compounds between using condensed matter laws and modified BCS theory. Firstly, we calculated the Tc by using the number density and momentum quantization for Fermi level but this concept is failed to explain the Tc for YBCO compounds. Secondly, critical temperature of YBCO compounds was derived by using a modified BCS theory. We assumed that the mechanism of Cooper pair formation in HTSC is due to the magnetic exchange resulting from random spin fluctuations for electrons, this result indicate the Tc is strongly dependent on the Debye temperature. After was taken experiments value for Debye temperature for YBCO, was calculated the critical temperature was given , recently we noticed the modified BCS theory its give better expression for Tc on YBCO than condensed matter.