1 September 2017 in Fluid Phase Equilibria
The file associated with this record is under embargo until 24 months after publication, in accordance with the publisher's self-archiving policy. The full text may be available through the publisher links provided above.Deep eutectic solvents (DESs) have been used for the purification of oils and the extraction of active ingredients from natural products but little is known about the mechanism of the extraction process. In this study a variety of molecular solutes are dissolved in alkanes and the thermodynamics of transfer into six DESs have been quantified. It is shown that the transfer of most solutes into the DES is endothermic and driven by entropy. The largest partition coefficients were demonstrated by the liquids with the lowest surface tensions and this is thought to arise because the enthalpy of hole formation controls the rate of solute transfer. Accordingly, it was shown that the size of the solute has an effect on the partition coefficient with smaller solutes partitioning preferably into the DES. As expected, solutes capable of strongly hydrogen bonding partitioned much better into the DES as the enthalpy of transfer was negative.Peer-reviewedPost-prin
19 October 2019 in Journal of Solid State Electrochemistry
AAAzhar Y. M. Al-Murshedi
8 January 2019 in Energy & Fuels
30 June 2021 in Polytechnic Journal
Aqueous carboxylic acids (CA) are generally used as attractive catalytic extractants in the field of desulfurization of petroleum products. In the present study, a triple system consisting of CA-ferric chloride-hydrogen peroxide has been used for the removal of aromatic S-compounds from partially hydrotreated diesel by liquid−liquid oxidative-extraction. The influence of various operating parameters affecting the oxidative desulfurization was experimentally investigated. Formic acid (HCOOH), acetic acid (CH3COOH), and propanoic acid (CH3CH2COOH) as aqueous solutions with hydrogen peroxide and iron(III) chloride (FeCl3) as oxidant and catalytic agent, respectively, were used. All experiments were carried out at 55°C with different oxidant to sulfur mole ratios (nH2O2/nS) (15–36), CA to sulfur mole ratios (nCA/nS) (2–26), and oxidation reaction times (5–25 min). Within 25 min of the treatment, a maximum elimination of aromatic S-compounds of 65.1% was obtained when molar ratio of oxidant to sulfur (nH2O2/nS) was 36 and molar ratio of CA to sulfur (nCA/nS) was 26. Surface tension calculations for the CAs demonstrated that the average void radius of the acids has a pronounced effect on the fitting of S-compounds from diesel fuel into acids and is important to sulfur removal. Further, increasing the desulfurization efficiency was also energetically affected in the presence of ferric halide. The obtention of the sulfur removal ability value was noticeably higher than was achieved by employing similar reaction conditions in the absence of FeCl3.