An automated device is designed to measure the density of a liquid material using hydrostatic pressure method. A low cost pressure sensor is calibrated and used to get highly accurate readings. The calibration is done by measuring the pressure values vs. the generated voltage signal. The calibration has been challenging due to the low accuracy of the sensor but proved to be highly effective in applications. The interface is developed using a microcontroller, motor drives, analog to digital converters and sensors. The device is designed to get several readings automatically by changing the positions of the device/liquid column heights to increase the accuracy. Also the device can be programmed to measure the real time density of a liquid continuously. The readings were analyzed and averaged by a software developed in python language. The instruments accuracy was tested against 3 liquid types, water, coconut oil, kerosene oil, and showed a low error (0.007%, 0.001%, and 0.002% respectively) compared to the readings of a standard Pycnometer. The low error percentages confirm the accuracy of the device and the effectiveness of the sensor calibrations.
Dye-sensitized solar cells (DSCs) have emerged recently as low-cost photovoltaic devices, giving impressive photovoltaic conversion efficiencies. However, the use of organic solvent-based liquid electrolytes in DSCs arises many problems in long-term applications. To overcome the drawbacks associated with the liquid electrolytes, quasi-solid-state electrolytes have been introduced. Hence, this study is focused on preparation of a novel gel electrolyte system using fumed silica as the gelling agent, γ-butyrolactone (γ-BL) as the plasticizer, tetrapropylammonium iodide (Pr4N+I−) as the salt and iodine. DSCs were assembled according to the configuration of glass/FTO/TiO2/dye (N719)/gel electrolyte/Pt/FTO/glass. The cell performances have been studied, by varying the amounts of Pr4N+I− salt and plasticizer in the gel electrolyte, in order to obtain the optimum conditions. The gel electrolyte containing weight percentages of 77% of γ-BL and 23% of Pr4N+I− salt gave the best light-to-electricity conversion efficiency of 6.33%, saturated current density of 15.7 mA cm-2 and open circuit voltage of 0.636 V under simulated AM 1.5 irradiation. Here, I-:I2 molar ratio was kept at 10:1 in the optimized gel system and fumed silica was added 10% of the total mass. The optimized gel composition is exhibited an ionic conductivity of 8.69×10-3 S cm-1 at 25 oC.