Two-dimensional simulations of ion beam driven fast ignition are presented. Ignition energies of protons with Maxwellian spectrum and carbon ions with quasimonoenergetic and Maxwellian energy distributions are evaluated. The effect of the coronal plasma surrounding the compressed deuterium-tritium is studied for three different fuel density distributions. It is found that quasimonoenergetic ions have better coupling with the compressed deuterium-tritium and substantially lower ignition energies. Comparison of quasimonoenergetic carbon ions and relativistic electrons as ignitor beams shows similar laser energy requirements, provided that a laser to quasimonoenergetic carbon ion conversion efficiency around 10% can be achieved.
Ion beam requirements for fast ignition are investigated by numerical simulation taking into account new effects, such as ion beam divergence, not included before. We assume that ions are generated by the TNSA scheme in a curved foil placed inside a re-entrant cone and focused on the cone apex or beyond. From the focusing point to the compressed core, ions propagate with a given divergence angle. Ignition energies are obtained for two compressed fuel configurations heated by proton and carbon ion beams. The dependence of the ignition energies on the beam divergence angle and on the position of the ion beam focusing point has been analyzed. Comparison between TNSA and quasi-monoenergetic ions is also shown.
Recent experiments of fast electron heating of aluminum foil targets have been analyzed by means of hybrid PIC simulations. A suitable initial angular distribution of fast electrons has been used and the diameter of the fast electron source has been fitted to reproduce with the same simulation parameters the beam divergence, Kα yields and temperatures at the target rear surface measured in the experiments. This results in a consistent description of the fast electron propagation that can be useful in general for simulations of laser-driven fast electron transport in dense media.
Fast ignition of a spherical compressed deuterium-tritium assembly induced by the energy deposition of laser-accelerated proton beams is considered. An efficient way to reduce the ignition energy consists of using a two proton beams scheme [M. Temporal, Phys Plasmas 13, 122704 (2006)]. For a uniformly compressed fuel at irradiated by proton beams with Maxwellian energy distribution with a temperature of , the ignition energy is using only one proton beam and reduces to a total of with the two-beam scheme. Further reduction of the ignition energy is found by using a first beam with annular radial profile and a second beam with the uniform radial profile. It is found that the first beam causes some additional fuel compression and confinement that decrease the total beam energy required for the ignition to , which is 40% smaller than in the case of a single beam with uniform radial profile.
Fast ignition of inertial fusion targets driven by quasi-monoenergetic ion beams is investigated by means of numerical simulations. Light and intermediate ions such as lithium, carbon, aluminum and vanadium have been considered. Simulations show that the minimum ignition energies of an ideal configuration of compressed Deuterium-Tritium are almost independent on the ion atomic number. However, they are obtained for increasing ion energies, which scale, approximately, as Z2, where Z is the ion atomic number. Assuming that the ion beam can be focused into 10 µm spots, a new irradiation scheme is proposed to reduce the ignition energies. The combination of intermediate Z ions, such as 5.5 GeV vanadium, and the new irradiation scheme allows a reduction of the number of ions required for ignition by, roughly, three orders of magnitude when compared with the standard proton fast ignition scheme.