Dean H. Levi

Dean H. Levi

Auto-generated profile, based on publicly available information

Dean H. Levi

National Renewable Energy Laboratory, Golden, CO, USA

Research Focus & Metrics

Academic Career Length

31Years (1996-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 August 2016 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
SJS. A. Jensen
S. A. Jensen
SGS. Glynn
S. Glynn
AKA. Kanevce
A. Kanevce
PDP. Dippo
P. Dippo
JLJ. V. Li
J. V. Li
DKD. Kuciauskas
D. Kuciauskas
World-record power conversion efficiencies for Cu(In,Ga)Se2 (CIGS) solar cells have been achieved via a post-deposition treatment with alkaline metals, which increases the open-circuit voltage and fill factor. We explore the role of the potassium fluoride (KF) post-deposition treatment in CIGS by employing energy- and time-resolved photoluminescence spectroscopy and electrical characterization combined with numerical modeling. The bulk carrier lifetime is found to increase with post-deposition treatment from 255 ns to 388 ns, which is the longest charge carrier lifetime reported for CIGS, and within ∼40% of the radiative limit. We find evidence that the post-deposition treatment causes a decrease in the electronic potential fluctuations. These potential fluctuations have previously been shown to reduce the open-circuit voltage and the device efficiency in CIGS. Additionally, numerical simulations based on the measured carrier lifetimes and mobilities show a diffusion length of ∼10 μm, which is ∼4 times larger than the film thickness. Thus, carrier collection in the bulk is not a limiting factor for device efficiency. By considering differences in doping, bandgap, and potential fluctuations, we present a possible explanation for the voltage difference between KF-treated and untreated samples.

1 March 2018 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
SKSarah Kurtz
Sarah Kurtz
IRIngrid Repins
Ingrid Repins
WMWyatt K. Metzger
Wyatt K. Metzger
PVPierre Jacques Verlinden
Pierre Jacques Verlinden
SHSusan Huang
Susan Huang
DLDean Levi
Dean Levi
Champion photovoltaic (PV) cell and module efficiencies have been reported in Progress in PV since 1993. Following the evolution of these efficiencies enables researchers to track the progress of various technologies. National Renewable Energy Laboratory has maintained a historical chart of the champion cell efficiencies, but has not published a similar chart of champion module efficiencies. Here, we analyze champion module efficiencies and compare them to champion cell efficiencies to better understand technology trends over the last three decades, highlighting that, in some cases, module efficiencies exceed 90% of cell efficiencies. Recommendations are provided on how to change the data collection and reporting for champion efficiencies to increase the value of these records.

2 October 2017 in Applied Physics Letters
Verified
Journal Article
Closed access
MKMark J. Koeper
Mark J. Koeper
CHCharles Hages
Charles Hages
JLJian V. Li
Jian V. Li
DLDean Levi
Dean Levi
RARakesh Agrawal
Rakesh Agrawal
Admittance spectroscopy is a useful tool used to study defects in semiconductor materials. However, metastable defect responses in non-ideal semiconductors can greatly impact the measurement and therefore the interpretation of results. Here, admittance spectroscopy was performed on Cu2ZnSn(S,Se)4 where metastable defect response is illustrated due to the trapping of injected carriers into a deep defect state. To investigate the metastable response, admittance measurements were performed under electrically and optically relaxed conditions in comparison to a device following a low level carrier-injection pretreatment. The relaxed measurement demonstrates a single capacitance signature while two capacitance signatures are observed for the device measured following carrier-injection. The deeper level signature, typically reported for kesterites, is activated by charge trapping following carrier injection. Both signatures are attributed to bulk level defects. The significant metastable response observed on kesterites due to charge trapping obscures accurate interpretation of defect levels from admittance spectroscopy and indicates that great care must be taken when performing and interpreting this measurement on non-ideal devices.

1 January 1996
Verified
Conference Paper
Open access
DRD.H. Rose
D.H. Rose
DLD.H. Levi
D.H. Levi
RMR.J. Matson
R.J. Matson
DAD.S. Albin
D.S. Albin
RDR.G. Dhere
R.G. Dhere
PSP. Sheldon
P. Sheldon
The presence of oxygen during close-spaced sublimation (CSS) of CdTe has been previously reported to be essential for high-efficiency CdS/CdTe solar cells because it increases the acceptor density in the absorber. The authors find that the presence of oxygen during CSS increases the nucleation site density of CdTe, thus decreasing pinhole density and grain size. Photoluminescence showed that oxygen decreases material quality in the bulk of the CdTe film, but positively impacts the critical CdS/CdTe interface. Through device characterization, they were unable to verify an increase in acceptor density with increased oxygen. These results, along with the achievement of high-efficiency solar cells (13% AM1.5) without the use of oxygen, led them to conclude that the use of oxygen during CSS deposition of CdTe can be useful but is not essential.

28 April 2017 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
MSM. A. Steiner
M. A. Steiner
EPE. E. Perl
E. E. Perl
JGJ. F. Geisz
J. F. Geisz
DFD. J. Friedman
D. J. Friedman
NJN. Jain
N. Jain
GHG. Horner
G. Horner
We demonstrate that in solar cells with highly reflective back mirrors, the measured internal quantum efficiency exhibits a shift in bandgap relative to the measured external quantum efficiency. The shift arises from the fact that the measured reflectance at the front surface includes a superposition of waves reflecting from the front and back surfaces. We quantify the magnitude of the apparent shift and discuss the errors that can result in determination of quantities such as the photocurrent. Because of this apparent shift, it is important the bandgap be determined from the external quantum efficiency.

20 October 2004
Verified
Conference Paper
Closed access
PDF file
DLD H Levi
D H Levi
JGJ F Geisz
J F Geisz
BJBlaine D Johs
Blaine D Johs
GaInP2 lattice-matched to GaAs or Ge plays an important role in state-of-the-art III-V multijunction solar cells. The fundamental band gap of constant-composition GaInP2 can be varied by as much as 100meV in metal-organic chemical vapor deposition (MOCVD) grown material by adjusting growth parameters that affect the degree of Cu-Pt ordering. These changes in the band gap of GaInP2 due to ordering can be exploited in the design of III-V solar cell devices. In order to accurately model the performance of these devices, accurate values of the optical constants of all layers are required. Previous literature reports of the optical properties of GaInP2 have primarily focused on highly disordered material or higher energy transitions in ordered material. While it has been noted that ordered GaInP2 material results in anisotropic optical properties, the bulk optical properties of GaInP2 as a function of ordering have not been sufficiently recorded in the literature for good optical modeling of III-V solar cell devices. In this paper, we present the dielectric functions for a range of ordered/disordered GaInP2 measured over the range 0.7-5.0 eV using spectroscopic ellipsometry. Data analysis of generalized ellipsometry data utilizing anisotropic multilayer models allows us to report accurate dielectric functions for both the ordinary and extraordinary optical axes.