3 April 2020 in Nature Communications
Picosecond strain pulses are a versatile tool for investigation of mechanical properties of meso- and nano-scale objects with high temporal and spatial resolutions. Generation of such pulses is traditionally realized via ultrafast laser excitation of a light-to-strain transducer involving thermoelastic, deformation potential, or inverse piezoelectric effects. These approaches unavoidably lead to heat dissipation and a temperature rise, which can modify delicate specimens, like biological tissues, and ultimately destroy the transducer itself limiting the amplitude of generated picosecond strain. Here we propose a non-thermal mechanism for generating picosecond strain pulses via ultrafast photo-induced first-order phase transitions (PIPTs). We perform experiments on vanadium dioxide VO2 films, which exhibit a first-order PIPT accompanied by a lattice change. We demonstrate that during femtosecond optical excitation of VO2 the PIPT alone contributes to ultrafast expansion of this material as large as 0.45%, which is not accompanied by heat dissipation, and, for excitation density of 8 mJ cm−2, exceeds the contribution from thermoelastic effect by a factor of five.
27 November 2018 in Journal of Applied Physics
Vanadium sesquioxide (V2O3) exhibits remarkable property changes through its metal-insulator transition near 150 K and is a very promising candidate for device applications. Thin V2O3 films were deposited on SiO2 glass by reactive DC magnetron sputtering. While resistivity changes over four orders of magnitude were demonstrated, films deposited under nominally identical conditions exhibited significant differences in electrical characteristics, which would hinder reproducibility under deposition techniques appropriate for industrial scale production with standard control features. These differences were attributed to small deviations from exact stoichiometry. A post-deposition thermal treatment consistent with equilibrium temperature and oxygen pressure conditions for V2O3 applied to the samples succeeded in nearly equalizing their characteristics within a relatively short time and without negatively impacting the glass substrate or film continuity. Analysis of film structure, morphology, and resistivity measured from room temperature through the metal-insulator transitions, both before and after the thermal process, revealed information about the interplay between non-stoichiometry, residual stress, and electrical characteristics of the films. The approach employed can lead to reproducible results for V2O3 films and is applicable to similar materials which exhibit metal-insulator transitions.
18 October 2013 in Journal of Applied Physics
Ultrafast hemispherical angle-resolved light scattering technique is applied to monitor the insulator-to-metal phase transition of highly oriented VO2 crystalline films, where transition is induced by femtosecond laser pulses. This approach reveals principal differences in transient dynamics of multi-scale VO2 grains for thermally and light-induced phase transformation, showing anisotropic and grain-size-dependent behavior with high resolution in space and time. Complete photoinduced transition occurs within 500 fs. However, VO2 grains of different sizes show different transition rates. The highest rate is found for clusters with lower concentration of structural defects and deformations. The twinning process in VO2 film is considerable for the thermally induced transition but is not detected for the ultrafast light-induced one.
14 May 2015 in Journal of Applied Physics
Experimental observation of metal-insulator transition in epitaxial films of vanadium dioxide is reported. Hemispherical angle-resolved light scattering technique is applied for statistical analysis of the phase transition processes on mesoscale. It is shown that the thermal hysteresis strongly depends on spatial frequency of surface irregularities. The transformation of scattering indicatrix depends on sample morphology and is principally different for the thin films with higher internal elastic strain and for the thicker films where this strain is suppressed by introduction of misfit dislocations. The evolution of scattering indicatrix, fractal dimension, surface power spectral density, and surface autocorrelation function demonstrates distinctive behavior which elucidates the influence of structural defects and strain on thermal hysteresis, twinning of microcrystallites, and domain formation during the phase transition.
12 January 2021 in Journal of Applied Physics
The observation of Raman-active mode softening is a powerful tool to understand phase transition mechanisms in solids. The evolution of the phonon spectrum of technologically important correlated oxide V O attracts much attention for the steady-state regime and for ultrashort temporal scales since thermal contribution to the insulator-to-metal (IMT) transition is excluded during the first few picoseconds. Here, we show theoretical modeling of V O phonon spectrum and experiment. It is shown that the IMT is a first-order phase transition. Photoinduced transition was observed by a elastic light scattering technique, showing the principal difference in V O surface dynamics across IMT for thermally and ultrafast light-induced phase transitions. The ultrafast IMT is accompanied primarily by short-range optical phonon interactions with a negligible contribution by acoustic phonons, while the acoustic phonons provide a key contribution to the transformation of surface geometry upon thermally induced IMT. Scattering imaging of surface autocorrelation function upon IMT shows the rise of optical homogeneity in the lateral direction of the surface in the steady-state regime and on a subpicosecond time scale.
26 September 2024 in Journal of Applied Physics
The experimental study of the angle-resolved hemispherical light scattering by V4O7 film within a broad temperature range across metal–insulator transition reveals complex structural reorganization of the film deposited on the c-cut sapphire crystal. The bidirectional scattering distribution function and the surface autocorrelation function were obtained from scattering data to visualize statistics of the spatially resolved contributions of optical inhomogeneities in normal and lateral directions to the surface. The measurements reveal an anisotropic surface roughness distribution due to the twinned domain structure, with significant anisotropy changes across the phase transition. The V4O7 film deposited on sapphire leads to a polydomain structure, minimizing elastic strain energy with distinct multiscale distributions of surface domains. Near Tc, the material shows the lowest roughness but the highest lateral disorder of the surface.