In this study, a simple method to obtain pure β-phase directly from the melt process is proposed. A series of PVDF and ionic liquid (IL) was prepared by a solvent casting method with appropriate associated with the subsequent annealing treatment. IL plays a role of filler, which can create strong electrostatic interaction with PVDF matrix and directly induce β-phase crystallization on the PVDF during the melt. PVDF film sample is immersed in hot water for annealing treatment at different temperatures (25 °C to 70 °C). We found that annealing in high temperatures especially can not only increase more IL inserted into the amorphous region of polymer matrix to make more phase transformation, but also accelerate IL removal. Characteristics and performance of the PVDF films were investigated by use of FTIR, XRD, SEM, and AFM. Piezoelectric coefficient d33 as well as d31, degree of crystallinity, and sensitivity are measured in experiment to verify the performance of PVDF film.
High exhaust gas opacity in conventional Diesel vehicles, such as the 2013 Mitsubishi L300 with its conventional injection system, remains a significant environmental challenge. This study aims to analyze the impact of blending three Diesel fuel types—Biosolar, Dexlite, and Pertamina Dex—on exhaust opacity levels. Conducted at the Motor Vehicle Testing Unit in Medan, the research employed an experimental method using a Smoke Opacity Meter to measure smoke opacity at various fuel mixture ratios. Data were subsequently analyzed using ANOVA to identify significant differences between treatments. The results demonstrate that fuel blending significantly influences opacity values. Notably, the combination of Pertamina Dex and Dexlite yielded the lowest opacity levels, achieving an average reduction of over 30% compared to pure Biosolar. This improvement is attributed to higher cetane numbers and lower sulfur content, which facilitate more complete combustion. The study concludes that fuel blending is a practical strategy for mitigating emissions in conventional Diesel engines, supporting the development of eco-friendly fuels and sustainable transportation policies in Indonesia.
18 December 2025 in IRA Jurnal Teknik Mesin dan Aplikasinya (IRAJTMA)
This study investigates the use of a Waste-Oil-Fueled Furnace (WOFF) as an alternative heat source in the melting process of recycled Al-3004 aluminum. The melting was carried out using the sand casting method at a pouring temperature of approximately 730 °C, while measurements indicated the furnace could reach ±900 °C, exceeding the melting point of Al-3004 (±660 °C). The cast specimens were subsequently quenched in three media: water, oil, and air. Microstructural observations revealed that the cooling rate significantly affected crack formation: water quenching produced the largest cracks, oil quenching produced medium-sized cracks, and air cooling produced the finest cracks. Micro Vickers hardness testing supported these findings, showing significant differences in hardness values across the quenching media. Overall, the study confirms that the waste-oil-fueled furnace is an effective alternative energy-based metal-melting technology, while the choice of cooling medium plays a crucial role in controlling the material's microstructural features and mechanical properties.