11 October 2017 in IEEE Transactions on Control Systems Technology
This paper proposes a practical method to realize multivariable full-state tracking control for industrial robots with elastic joints. Unlike existing methods, the proposed method does not require high-order derivatives of the link states such as acceleration and jerk. Therefore, the proposed method does not suffer from chatter related to inaccurate estimation of high-order derivatives. The method is derived by adopting a singular perturbation technique. A decoupled error dynamics is achieved by two decoupling control loops: a fast loop that controls the deflection error and a slow loop for tracking control on the link side. Our stability analysis based on a linear system shows that the proposed control system is stable as long as the fast system is at least twice as fast as the slow system. A practical method to select the gain is also presented such that the closed-loop poles are placed at the desired locations. In simulation, we compare the proposed method with feedback linearization. The results indicate that in an ideal scenario the proposed method can obtain a similar performance as feedback linearization. However, the proposed method obtains a superior performance in a realistic scenario. A real-world experiment with a six degree-of-freedom commercial industrial robot is carried out to further validate our approach.
1 August 2019 in Robotics and Computer-Integrated Manufacturing
1 December 2018 in Robotics and Computer-Integrated Manufacturing
31 August 2017 in IEEE Transactions on Industrial Electronics
This paper presents a novel multivariable two-time scale control method for flexible joint robots. The fundamental limitations of the conventional two-time scale control are clearly explained based on a singular perturbation analysis with a linearized dynamic model. Unlike the conventional methods, the bandwidth of the slow control can be made high and the derivatives of the rigid control are not required. The closed-form solution of a slow model that is more accurate than the rigid model is presented. It is shown that the modeling error of the proposed two-time scale control can be made arbitrarily small by the control gain only. A real-world experiment with a six degrees-of-freedom commercial industrial robot was performed to validate the presented approach.
2 August 2019 in IEEE Transactions on Industrial Electronics
The paper presents a novel method to generate a trajectory for a two-wheeled mobile robot moving in an uncertain environment where only a few way-points are available to reach a nearby target state. The proposed method interpolates way-points by combination of a straight-line and a fifth-order Bezier curve along which the curvature varies continuously. In addition, a method to generate the associated timing-law is proposed such that the robot travels along the curve in near minimum-time under the maximum velocity and torque constraints. Since the method aims for an online application, heuristic techniques are applied to minimize the computational cost for finding the optimal solution. The time for computing a complete time-optimal trajectory for a moving robot to transit to a next way-point is only several milliseconds when tested in a personal computer. This result implies that a highly efficient motion control system for a two-wheeled mobile robot can be implemented with a low-cost hardware available today.
14 April 2022 in Mechatronics