Carbon quantum dots (CQDs)-ZnO composite thin films were prepared via ultrasonic mist vapour deposition (UMVD) method. The effect of different CQDs concentrations (C), substrate temperatures (Ts), nozzle-substrate distances and also post-annealing process on the thin film structure were considered and examined systematically. The effects of these parameters on optical, morphological and surface properties of the layers as well as their wettability were carefully investigated and discussed. It was found that for low Ts and short ‘d’, CQDs diffuse inside the layer during deposition and then were evaporated after annealing process making drastic changes in layer morphology and optical transmittance. On the other hand, for high Ts and long ‘d’, most of CQDs inside mist vapour drops are evaporated during deposition process. Therefore, the layer transmittance and morphology did not change notably after annealing. Interestingly, the layer prepared with C = 5 volume %, Ts = 470 °C and d = 9 cm was turned to super-hydrophilic surface after annealing process with contact angle of ⁓ 3º. Such a super-hydrophilic CQDS-ZnO thin film is highly beneficial for a wide range of applications which high wettability is required.
Molybdenum-doped BiVO4 thin films were uniformly coated on indium-doped tin oxide (ITO) substrates via a facile modified hot spin coating (HSC) technique. The prepared layers were used as photoanode in a photoelectrochemical (PEC) cell. Different percentage of Mo dopant was examined to maximize the photo-current density (J) of the layers. The highest J value (872 ± 8 μA/cm2) was obtained by 5 atomic% of Mo doping. After that, the surface topographies of these samples were changed by varying the initial precursor concentration from 27 to 80 mM. The relation between surface topographies and the PEC activity of Mo-doped BiVO4 thin films was investigated from microscopic point of view by calculating the surface roughness exponent of α, and a mechanism for the PEC activity of Mo-doped BiVO4 photoanodes was proposed accordingly. The sample with a small roughness exponent provided a surface with jagged microscopic fluctuations which may trap the air molecules between the electrolyte and sample surface, hindering the fine atomic interaction for photo-generated electron-hole transition. Therefore, the layer with the highest roughness exponent (2α = 0.48 ± 0.03), which means the smoother microscopic surface and better interfacial contact with the electrolyte, exhibited the best PEC activity.