1 February 2017 in Geochimica et Cosmochimica Acta
28 February 2022 in Geochemistry, Geophysics, Geosystems
Heat flux from the core to the mantle provides driving energy for mantle convection thus powering plate tectonics, and contributes a significant fraction of the geothermal heat budget. Indirect estimates of core‐mantle boundary heat flow are typically based on petrological evidence of mantle temperature, interpretations of temperatures indicated by seismic travel times, experimental measurements of mineral melting points, physical mantle convection models, or physical core convection models. However, previous estimates have not consistently integrated these lines of evidence. In this work, an interdisciplinary analysis is applied to co‐constrain core‐mantle boundary heat flow and test the thermal boundary layer (TBL) theory. The concurrence of TBL models, energy balance to support geomagnetism, seismology, and review of petrologic evidence for historic mantle temperatures supports QCMB ∼15 TW, with all except geomagnetism supporting as high as ∼20 TW. These values provide a tighter constraint on core heat flux relative to previous work. Our work describes the seismic properties consistent with a TBL, and supports a long‐lived basal mantle molten layer through much of Earth's history.
15 February 2022 in Geochemistry, Geophysics, Geosystems
The relative composition of Earth's core and mantle were set during core formation. By determining how elements partition between metal and silicate at high pressures and temperatures, measurements of the mantle composition and geophysical observations of the core can be used to understand the mechanisms by which Earth formed. Here we present the results of metal‐silicate partitioning experiments for a range of nominally lithophile elements (Al, Ca, K, Mg, O, Si, Th, and U) and S to 85 GPa and up to 5400 K. With our results and a compilation of literature data, we developed a parameterization for partitioning that accounts for compositional dependencies in both the metal and silicate phases. Using this parameterization in a range of planetary growth models, we find that, in general, lithophile element partitioning into the metallic phase is enhanced at high temperatures. The relative abundances of FeO, SiO2, and MgO in the mantle vary significantly between planetary growth models, and the mantle abundances of these elements can be used to provide important constraints on Earth's accretion. To match Earth's core mass and mantle composition, Earth's building blocks must have been enriched in Fe and depleted in Si compared with CI chondrites. Finally, too little Mg, Si, and O are partitioned into the core for precipitation of oxides to be a major source of energy for the geodynamo. In contrast, several ppb of U can be partitioned into the core at high temperatures, and this energy source must be accounted for in thermal evolution models.
22 September 2021 in Physical Review B
The alkali halides are often used as optically-transparent pressure-transmitting media and thermal insulators in laser-heated diamond anvil cell experiments. High P–T equations of state for these materials would allow them to be used simultaneously as sensitive in situ pressure markers, making sample preparation and data analysis simpler. KCl is especially useful for this application because its high melting point, crystallographic simplicity, and low electron density are ideal for use in high-temperature x-ray diffraction experiments. However, the high-temperature static equation of state data for this material is limited in pressure to 8 GPa. As experiments routinely exceed 100 GPa in pressure and thousands of Kelvin, it is necessary for the equation of state of KCl to be determined experimentally at these conditions if it is to be used as an equation of state calibrant in the future. This paper combines new high-pressure, high-temperature data of the B2 phase of KCl (up to 167 GPa and 2400 K) with the previously published room-temperature data of Dewaele et al. [ Phys. Rev. B 85, 214105 (2012)] to produce a Mie-Grüneisen-Debye thermal equation of state for this material. The room-temperature equation of state parameters are similar to those reported previously: GPa, and . The thermal parameters, and are 2.9(4) and 1.0(1), respectively. While a of 1 is expected, the is higher than expected from previous calculations, lower pressure experimental data, and the available shockwave data. Thus, previously-reported equations of state underestimate the pressure of KCl at high temperatures.
2 May 2016 in American Mineralogist: Journal of Earth and Planetary Materials
The high-cosmic abundance of sulfur is not reflected in the terrestrial crust, implying it is either sequestered in the Earth’s interior or was volatilized during accretion. As it has widely been suggested that sulfur could be one of the contributing light elements leading to the density deficit of Earth’s core, a robust thermal equation of state of iron sulfide is useful for understanding the evolution and properties of Earth’s interior. We performed X-ray diffraction measurements on FeS2 achieving pressures from 15 to 80 GPa and temperatures up to 2400 K using laser-heated diamond-anvil cells. No phase transitions were observed in the pyrite structure over the pressure and temperature ranges investigated. Combining our new P-V-T data with previously published room-temperature compression and thermochemical data, we fit a Debye temperature of 624(14) K and determined a Mie-Grüneisen equation of state for pyrite having bulk modulus KT = 141.2(18) GPa, pressure derivative K′T = 5.56(24), Grüneisen parameter γ0 = 1.41, anharmonic coefficient A2 = 2.53(27) × 10−3 J/(K2·mol), and q = 2.06(27). These findings are compared to previously published equation of state parameters for pyrite from static compression, shock compression, and ab initio studies. This revised equation of state for pyrite is consistent with an outer core density deficit satisfied by 11.4(10) wt% sulfur, yet matching the bulk sound speed of PREM requires an outer core composition of 4.8(19) wt% S. This discrepancy suggests that sulfur alone cannot satisfy both seismological constraints simultaneously and cannot be the only light element within Earth’s core, and so the sulfur content needed to satisfy density constraints using our FeS2 equation of state should be considered an upper bound for sulfur in the Earth’s core.
9 August 2011 in The Journal of Physical Chemistry A