The strength and permeability of fault zones must be quantified in order to accurately predict crustal strength and subsurface fluid migration. To this end, we performed experiments on mixtures of fine‐grained quartz and kaolinite incremented at 10 wt% intervals between the two end‐member components (analogues for natural fault gouge) in order to establish their strength and fluid flow properties during hydrostatic and shear loading. Hydrostatically compacted samples exhibited permeability reduction on increasing effective pressures from 5 MPa to 50 MPa, with the rate of reduction displaying strong dependency on the synthetic fault gouge composition. The permeability decreases continuously with increasing kaolinite content. Porosity exhibits a distinct minimum that evolves with increasing effective pressure according to the relative compaction of the quartz and kaolinite end‐members. Porosity evolution with increasing clay content is predicted satisfactorily by a simple ideal packing model. At the highest effective pressure (50 MPa), permeability reduced log‐linearly over 4 orders of magnitude with increasing clay content. Mechanically, sheared gouge samples showed a continuous reduction in frictional strength with increasing clay fraction. Permeability decreased further on shear loading after initial hydrostatic compaction to 50 MPa. This was most evident for the pure quartz end‐member, with two orders of magnitude additional reduction, whereas the clay‐rich samples were reduced only tenfold, mostly before a shear strain of 5. Variation of permeability with both clay content and shear deformation may be adequately described by previously published empirical predictors for fault zone permeability. Clay content has the largest effect on permeability, and shear deformation affects permeability of quartz‐rich gouges more than clay‐rich gouges.
[1] Subduction zone earthquakes can propagate to the surface causing large seafloor displacements resulting in tsunamis. This requires the earthquake to rupture through clay‐rich sediments of the accretionary wedge, which are largely aseismic. As found previously, the frictional properties of a range of wet clays at low slip velocity are velocity strengthening, thus inhibiting earthquake nucleation. However, at high slip velocity the same materials weaken almost immediately resulting in a negligible critical slip weakening distance and fracture energy. We interpret this behaviour as rapid thermal pressurization of the pore fluid within the clay gouge. The lack of fracture energy can explain how a large rupture, propagating from depth, might not be arrested by clay‐rich, velocity‐strengthening sediments, as is commonly seen. The results suggest that generally, earthquakes may be difficult to nucleate on mature faults dominated by clay, but the propagation of earthquakes through these zones is energetically very favourable.
1 July 2012 in Earth and Planetary Science Letters