The last twenty years have witnessed increasing research activity in the area of supramolecular chemistry of 1 : 1 co-assembly of melamine (M)–cyanuric acid (CA), since the historic discovery of the M·CA aggregate in crystal form and its structural analysis by Wang and his coworkers in 1990. Its useful chemical structure and fascinating H-bonding interaction sites distinguish M and its analogous derivatives as scaffolding components in the field of supramolecular chemistry to develop desired nano-to-micro scaled architecture. To date, M-based supramolecular assemblies are known in diverse forms which include fascinating nano- to micromorphological structures, molecular guest boxes, small molecular gels, membrane, sensor and liquid crystal development, polymeric scaffolds etc. In this review, we have covered the development of M and its derivatives, encompassing both nano/micro-ordered structures and advanced functional materials.
The folic acid (F) gel, prepared in a 1 : 1 dimethyl sulfoxide (DMSO)–water mixture (v/v), at 0.2% (w/v) concentration has a nano-fibrous network morphology. FTIR spectra indicate the presence of intermolecular H-bonding interactions in the gel. The folic acid–chitosan (C) hybrid (FC) gel (prepared by mixing 0.1 ml of 1% (w/v) C solution with 2 ml 0.2% (w/v) F solution) appears as a yellow transparent semi-solid mass consisting of a nano-fibrous network with a higher density of branches. The fibrillar diameter of the FC hybrid gel (10.5 nm) is much lower than that of F gel (17.3 nm). The FTIR band at 3390 cm−1 of F gel shows a shift to 3435 cm−1 in the FC hybrid gel indicting a hydrogen bonding interaction between C and F. The fluorescence intensity of the FC hybrid gel is enhanced by 2.75 times than that of F gel. The shear viscosity of FC hybrid gel is 3 orders higher than that of the F gel and both gels exhibit shear thickening at a low shear rate (<10−3 s−1) but above that, shear-thinning occurs. In the creep phase, the FC hybrid gel exhibits strain recovery but the F gel does not. The complex modulus (G*) of both systems initially exhibit a sharp increase, followed by a slow increase with time (t) and dG*/dt varies with C concentration in the FC hybrid gel showing a maximum. The WAXS pattern of the FC hybrid xerogel does not exhibit any crystalline peak, suggesting that the additive (C) inhibits the crystallization of F. The dye absorption by the hybrid gel material is maximum for Eosin Yellow, (83.5%), however, Methyl Orange and Methylene Blue are absorbed to a lesser extent (∼40%). The FC hybrid gel absorbs 55% of Cu2+, 67.2% of Cr3+ and 49% of Co2+ from their respective solutions.
N-Flourenylmethoxycarbonyl (Fmoc) phenylalanine (F) produces co-assembled organogel with 2-aminoanthracene (AA) and 2-aminonaphthalene (NA) at a 1 : 1 molar ratio of the components. The deep green co-assembled F-AA gel is rigid and can be cut into different shapes. At lower concentration, 0.2% (w/v), it shows a mixture of fibre and flake morphology, while at 1.5% (w/v) concentration only flake morphology is observed but the F-NA co-assembled gel produces tape morphology. The powder diffraction data of F-AA co-assembled gel indicate π–π stacking and lamellar packing which is supported by DFT calculation. The melting point of F gel is 15 °C higher over F-AA gel but the gel strength and stiffness of the F-AA co-assembled gel is 94 and 2.5 times higher than that of F gel. The F gel shows a smooth gel breaking point at 4 Pa but the F-AA co-assembled gel shows only a slippage at 160 Pa due to its high stiffness. The UV-vis spectra suggest the formation of H-aggregates and a charge transfer complex in the F-AA gel. The emission peak of AA shows a red shift in the F-AA co-assembled gel where both fluorescence intensity and peak position decrease with an increase in temperature. The F-AA xerogel shows semiconducting behaviour with a dc conductivity value 2.3 × 10−8 S cm−1 and the I–V characteristic curves indicate a semiconducting nature with a signature of negative differential resistance.
23 August 2019 in Bulletin of the Chemical Society of Japan
Molecular architectonics has its essence in custom design and engineering of molecular assemblies by judicious exploitation of the noncovalent forces to construct ordered architectures with novel properties and functions. The art of mastering the programmed molecular assemblies is a challenging task owing to complex factors that govern recognition events at the molecular level. In this context, biomolecules with in-built information for molecular recognition are capable of guiding the molecular architectonics to construct nano, micro, and macro-architectures with functional properties and applications. In particular, amino acids and peptides are attractive auxiliaries to guide the controlled molecular self-assembly, coassembly, heterostructures and living assembly systems of functional molecules in the scheme of molecular architectonics. Use of these exquisite biomolecular auxiliaries to master the art of engineering the molecular assembly of functional aromatic units viz., arylenediimides has been a continuous effort in the emerging field of molecular architectonics. In this accounts article, we outline the amino acid and peptide functionalized arylenediimide-based designer molecular systems as functional modular units developed by our group and others with an objective to demonstrate the concept of molecular architectonics to construct functional nano, micro and macroarchitectures with wide range of properties and applications.