11 December 2023 in Modeling and Analysis of Information Systems
АРАртём Валерьевич Рябинов
This article describes a series of experiments in the Gazebo simulation environment aimed at studying the influence of external weather conditions on the automatic landing of an unmanned aerial vehicle (UAV) on a moving platform using computer vision and a previously developed control system based on PID and polynomial controllers. As part of the research, methods for modeling external weather conditions were developed and landing tests were carried out simulating weather conditions such as wind, light, fog and precipitation, including their combinations. In all experiments, successful landing on the platform was achieved; during the experiments, landing time and its accuracy were measured. The graphical and statistical analysis of the obtained results revealed the influence of illumination, precipitation and wind on the UAV landing time, and the introduction of wind into the simulation under any other external conditions led to the most significant increase in landing time. At the same time, the study failed to identify a systemic negative influence of external conditions on landing accuracy. The results obtained provide valuable information for further improvement of autonomous automatic landing systems for UAVs without the use of satellite navigation systems.
24 January 2025 in International Journal of Intelligent Unmanned Systems
Purpose: A new method for positioning a group of unmanned aerial vehicles (UAVs) that collect data from seismic modules via wireless communication is proposed. Design/methodology/approach: The developed method of positioning a group of UAVs includes five main stages: constructing a heat map of Wi-Fi signal propagation, identifying points of maximum signal strength on the heat map, optimal target distribution between UAVs in the group, constructing optimal trajectories considering the complexity of the terrain and resolving conflict situations. The proposed algorithms were implemented programmatically in the ROS2 system in C++, then their operation was simulated in the Gazebo simulation environment. Findings: Simulation of flights of a group of 4, 7 and 10 UAVs in areas of 5 × 5 and 10 × 10 sq km with the presence of 60 and 180 peaks respectively with a height from −50 to −63 dBm, using the developed method made it possible to solve the problem of collecting data from seismic sensors via a wireless communication channel in 34, 18 and 11 min for each group in 5 × 5 area and 83, 37, 32 min for 10 × 10 area. The comparison with other methods showed scalability and performance improvements by an average of 6–18%, depending on the number of UAVs in the group. Originality/value: The main advantage of this method is the formation of global reciprocating trajectories of a group of UAVs, covering the coordinates of all seismic sensors in the minimum possible time and the iterative construction of local reciprocating trajectories in the process of flying around each sensor.
7 April 2025 in Proceedings of the Southwest State University
Purpose of research. Evaluation of the effectiveness of the UAV automatic landing system on a mobile platform using an infrared beacon based on criteria for landing accuracy and maneuver success at various altitudes. Methods. Modeling the process of movement of a complex object (UAV) in the Gazebo environment using the ROS ecosystem. The positioning of the UAV is based on a mathematical model of an infrared beacon consisting of four pairs of emitters. The landing algorithm includes adaptive PID controllers for the X and Y coordinates and a logo polynomial controller to ensure the descent of the UAV along the Z axis. Results. The UAV landing was tested 50 times from heights of 5 m, 10 m and 15 m. At a height of 5 m, the landing time was 9.04 seconds (0.504 sec deviation), the error was 0.18 m (0.035 m deviation), the success rate was 100 %. At 10 m, the time increased to 19.17 seconds (1.78 sec deviation), the error was 0.19 m (0.036 m deviation), the success rate remained 100 %. At 15 m, the time increased to 40.45 seconds (5.502 seconds deviation), the error was 0.21 m (0.046 m deviation), the data distribution became wider, outliers appeared, the success rate decreased to 92 %, which is due to signal losses, their attenuation and the need to correct the trajectory. Increasing the height of the landing process testing is impractical due to a decrease in the probability of a successful landing. Conclusion. The study showed that the infrared beacon system works effectively for landing UAVs on a mobile platform at altitudes up to 10 m, providing the necessary stability and accuracy. At altitudes above 10 m, problems arise with loss of signals, increased landing time and errors, which require improvements to ensure the reliability of landing.