Masato Kotsugi

Masato Kotsugi

Auto-generated profile, based on publicly available information

Masato Kotsugi

Tokyo University of Science

Research Focus & Metrics

Academic Career Length

29Years (1998-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 March 2009 in Physical Review B
Verified
Journal Article
Closed access
PDF file
HHH. Hibino
H. Hibino
HKH. Kageshima
H. Kageshima
MKM. Kotsugi
M. Kotsugi
FMF. Maeda
F. Maeda
FGF.-Z. Guo
F.-Z. Guo
YWY. Watanabe
Y. Watanabe
We used spectroscopic photoemission and low-energy electron microscopy to investigate the electronic properties of epitaxial few-layer graphene grown on 6H-SiC(0001). Photoelectron emission microscopy (PEEM) images using secondary electrons (SEs) and C 1s photoelectrons can discriminate areas with different numbers of graphene layers. The SE emission spectra indicate that the work function increases with the number of graphene layers and that unoccupied states in the few-layer graphene promote SE emission. The C 1s PEEM images indicate that the C 1s core level shifts to lower binding energies as the number of graphene layers increases, which is consistent with the reported thickness dependence of the Dirac point energy.

30 August 2000 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
YSY. Saitoh
Y. Saitoh
HKH. Kimura
H. Kimura
YSY. Suzuki
Y. Suzuki
TNT. Nakatani
T. Nakatani
TMT. Matsushita
T. Matsushita
SSS. Suga
S. Suga
We report on the excellent performance of a newly constructed soft x-ray helical undulator beamline BL25SU of SPring-8 for photon energies 500–1800 eV. The full beamline was designed to perform very high resolution soft x-ray spectroscopy of solids with using high brilliance, highly circularly polarized undulator radiation. The grazing incidence monochromator employs varied-line-spacing plane gratings which operate in convergent light from a spherical mirror and focuses monochromatic light onto the exit slit. A resolving power in excess of 15 000 was measured at 540 and 870 eV for a grating with a central groove density of 600 lines/mm from the photoemission spectra of Au. A resolving power of more than 20 000 is estimated near 870 eV for a grating with a central groove density of 1000 lines/mm. A photon flux of more than 1×1011 photons/s/100 mA/0.02% b.w. is supplied onto the sample between 500 and 1800 eV with very low amount of higher-order light. The low heat load from the twin-helical undulator gives high stability to all optical components, which is essential to obtain high resolution in a wide energy region. Three experimental stations are installed in tandem on this beamline for various high resolution spectroscopy measurements.

8 January 2006 in Nature Materials
Verified
Journal Article
Closed access
WKW. Kuch
W. Kuch
LCL. I. Chelaru
L. I. Chelaru
FOF. Offi
F. Offi
JWJ. Wang
J. Wang
MKM. Kotsugi
M. Kotsugi
JKJ. Kirschner
J. Kirschner

27 January 2014 in Journal of Physics: Condensed Matter
Verified
Journal Article
Closed access
TKTakayuki Kojima
Takayuki Kojima
MOMisako Ogiwara
Misako Ogiwara
MMMasaki Mizuguchi
Masaki Mizuguchi
MKMasato Kotsugi
Masato Kotsugi
TKTomoyuki Koganezawa
Tomoyuki Koganezawa
KTKoki Takanashi
Koki Takanashi
We prepared L10-ordered FeNi alloy films by alternate deposition of Fe and Ni monatomic layers, and investigated their magnetic anisotropy. We employed a non-ferromagnetic Au-Cu-Ni buffer layer with a flat surface and good lattice matching to L10-FeNi. An L10-FeNi film grown on Au6Cu51Ni43 showed a large uniaxial magnetic anisotropy energy (Ku = 7.0 × 10(6) erg cm(-)3). Ku monotonically increased with the long-range order parameter (S) of the L10 phase. We investigated the Fe-Ni composition dependence by alternating the deposition of Fe 1 − x and Ni 1 + x monatomic layers (− 0.4 < x < 0.4). Saturation magnetization (Ms) and Ku showed maxima (Ms = 1470 emu cm(-3), Ku = 9.3 × 10(6) erg cm(-3)) for Fe60Ni40 (x = -0.2) while S showed a maximum at the stoichiometric composition (x = 0). The change in the ratio of lattice parameters (c/a) was small for all compositions. We found that enrichment of Fe is very effective to enhance Ku. The large Ms and Ku of Fe60Ni40 indicate that Fe-rich L10-FeNi is promising as a rare-earth-free permanent magnet.

2 September 2014 in Philosophical Magazine Letters
Verified
Journal Article
Closed access
SLSeungwon Lee
Seungwon Lee
Kaveh EdalatiKaveh Edalati
Kaveh Edalati
HIHideaki Iwaoka
Hideaki Iwaoka
ZHZenji Horita
Zenji Horita
TOTakumi Ohtsuki
Takumi Ohtsuki
KTKoki Takanashi
Koki Takanashi
FeNi with the L10-ordered structure is formed over an astronomical timescale in meteorites. In this study, severe plastic deformation using high-pressure torsion (HPT) is employed for the production of the L10 structure in the laboratory. Its formation is confirmed by X-ray diffraction analysis and transmission electron microscopy. Processing of elemental nanopowders by HPT is an effective method for the formation of the L10 phase, which is enhanced by the addition of Co to FeNi or annealing after HPT. The formation of the phase must be associated with enhanced diffusion through HPT.

6 July 2009 in Applied Physics Letters
Verified
Journal Article
Closed access
PDF file
RYRyo Yasuhara
Ryo Yasuhara
KFK. Fujiwara
K. Fujiwara
KHK. Horiba
K. Horiba
HKH. Kumigashira
H. Kumigashira
MKM. Kotsugi
M. Kotsugi
HTH. Takagi
H. Takagi
The spatial distribution of chemical states in resistance-switching devices with a planar-type Pt/CuO/Pt structure has been studied by photoemission electron microscopy. It has been found that the change in resistance that occurs with the application of the first voltage is caused by the formation of a reduction path through the CuO channel between the Pt electrodes. A detailed analysis suggests that Joule-heat-assisted reduction induced by the current flowing through the device may play an important role in the formation of the conductive reduction path.