30 March 2018 in IEEE/ASME Transactions on Mechatronics
In this paper, a practical dynamic path tracking (DPT) scheme for industrial robots is presented. The DPT scheme is a position-based visual servoing to realize three-dimensional dynamic path tracking by correcting the robot movement in real time. In the traditional task-implementation mode for industrial robots, the task planning and implementation are taught manually and hence the task accuracy largely depends on the repeatability of industrial robots. The proposed DPT scheme can realize automatic preplanned task and improve the tracking accuracy with eye-to-hand photogrammetry measurement feedback. Moreover, an adaptive Kalman filter is proposed to obtain smooth pose estimation and reduce the influence caused by image noise, vibration, and other uncertain disturbances. Due to high repeatability of the photogrammetry sensor, the proposed DPT scheme can achieve a high path tracking accuracy. The developed DPT scheme can be seamlessly integrated with the industrial robot controller and improve the robot's accuracy without retrofitting with high-end encoder. By using C-track 780 from Creaform as the photogrammetry sensor, the experimental tests on Fanuc M20-iA with the developed DPT scheme demonstrate the tracking accuracy is significantly improved (±0.20 mm for position and ±0.10 deg for orientation).
1 July 2018 in International Journal of Advanced Robotic Systems
In this article, a dynamic pose correction scheme is proposed to enhance the pose accuracy of industrial robots. The dynamic pose correction scheme uses the dynamic pose measurements as feedback to accurately guide the robot end-effector to the desired pose. The pose is measured online with an optical coordinate measure machine, that is, C-Track 780 from Creaform. A root mean square method is proposed to filter the noise from the pose measurements. The dynamic pose correction scheme adopts proportional-integral-derivaitve controller and generates commands to the FANUC robot controller. The developed dynamic pose correction scheme has been tested on two industrial robots, FANUC LR Mate 200iC and FANUC M20iA. The experimental results on both robots demonstrate that the robots can reach the desired pose with an accuracy of ±0.050 mm for position and ±0.050° for orientation. As a result, the developed pose correction can make the industrial robots meet higher accuracy requirement in the applications such as riveting, drilling, and spot welding.
18 November 2024 in International Journal of Advanced Robotic Systems
In this article, an adaptive iterative learning control (AILC) scheme has been proposed to enhance the accuracy of the dynamic path tracking of 6-degrees of freedom industrial robots. Based on the memorized data and current feedback from a three-dimensional visual measurement instrument, an adaptive algorithm is developed to update the time-varying control parameters of the AILC scheme iteratively. A new compensation signal is calculated to adjust the control inputs produced by the dynamic path tracking control module at each time interval. Through the adaptation algorithm, the identical initial conditions can be relaxed to some extent with the AILC scheme. Moreover, the stability analysis of the proposed AILC scheme is presented. Experimental results on FANUC M20iA, using C-Track 780 as a photogrammetry sensor, demonstrate the superior performance of the developed AILC scheme in terms of pose accuracy, disturbance rejection ability, and control performance.